Question about 2007 Chevrolet Optra 1.6

Open Question

Hi.i need a key remote circute diagram for Chevrolet optra 2007.thanks

Hi.the + ter.fall down from the circute and we can not figure out where its location .we fixed the + ter.wiht a jumper wire in the circute and i think it is not the right place the led light is working and i can start the car but i can not open the car by the remote.also how can i get a remote control key.thanks alot

Posted by on


6 Suggested Answers



Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Anand Kumar

  • 2035 Answers

SOURCE: need schematic for location of ECM on 2002 Chev Silverado 5.3L GAS ENGINE

Please use this link :

Good luck...

Posted on Aug 14, 2008


Ronald Mueller

  • 1263 Answers

SOURCE: 2007 HHR Wiring diagram

is there spark? is their fuel? also if it was wrecked chances are that the fuel cut-off switch was triggered. i have not ever worked on one so i don't exactly know where it is but i would check behind the fabric/hard plastic right rear/left rear wheel hosing and see if you can hit the reset switch. another suggestion is go to napa or oreillys and get a repair manual for it it has diagrams and schematics in it and it cost about 20 bucks.....good luck please rate this.....thanks

Posted on Sep 01, 2008


  • 1 Answer

SOURCE: my keyless remote doesn't work...whenever

I disconnected the battery then hook it back up and all was okay again, that simple!!
I wonder what they would of charged me for that at the dealer?

Posted on Sep 09, 2008


  • 120 Answers

SOURCE: 2007 Chevy Equinox - with

believe it or not you need to take it to the dealer. There is a software reprogram for the remote control door lock receiver to fix the probelm - really common on tahoes and suburbans. Go to the dealer and tell them about bulletin #06-08-52-002g. It probably will need new remotes also. Try and get the dealer to warranty it since its a known product defect and a known problem

Posted on May 03, 2009


  • 1 Answer

SOURCE: 2007 Chevrolet Uplander LT ABS and TC light on

We were having this problem...have your wheel bearing checked out. There was a sensor in the drivers side wheel bearing...once we replaced it (because it was going out) the ABS and Traction Control warning lights stopped coming on.

Posted on Jul 02, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have toyota HILUX 2010 workmate my horn stopped working and air bag light is on macanic said its relay problem does anyone know where is relay located and can I change by myself Thanks in advance

Hi there is no relay on the horn circut. And the airbag is a separate circut. It could be the airbag squib it is a cool of wire under the stering wheel that feeds the horn and airbag. Get it pluged in and diagnosed to confirm. Regards Jim...

Apr 14, 2015 | Toyota Hilux Cars & Trucks

1 Answer


I had the same problem with mine! I spent what seemed like hours trying to figure it out. I finally gave up and just said, while I'm here I'll just do all my preventative maintenance checks and give up for now. I noticed while checking the radiator that the antifreeze was low so I added a little less than a couple of quarts, closed the hood, started it to move it back to the driveway and guess what? It fixed itself! I guess it was just low enough on fluid it was telling itself, "I need to warm up." Hey, maybe you'll get lucky and the same simple thing might be the problem. Also their is a (usually vac. controlled) switch located on the throttle linkage that allows your engine to de-accelerate "softer" instead of just dropping all at once when you let off the gas. I have seen these switches with age or dirt and grime, stick in a position that the throttle wont fall all the way down. A couple of things to check that my be a simple fix. Hope all works out for you!

Jan 20, 2015 | 1985 Honda Accord

2 Answers

Hi the passenger side window rolled down one day and wouldnt roll back up so we did some checking and discovered the motor was good so we figured,and was told it probably was the master switch on the...

Need to get a wiring diagram. Buy a book and follow the wiring schematic. It should help you out majorly. Can't really work on electrical issues without one.

Mar 17, 2013 | 2000 Oldsmobile Silhouette

2 Answers

Locate cabin air filter for 2006 kia sorento

Hi. The 2006 Kia sorento is not equipped wiht a cabin air filter. Only the 07 and 08 sorentos are equipped wiht this filter. With that said; If your vehicel had a filter, it would be located just behind the glove box. If you were to access it for replacment, you would Open the glove box and remove the side stops so the glove box can swing fully down and hang on its hinges. Once that is done, you will be able to access to the cabin air filter and the clips which hold it in place.

Aug 23, 2010 | 2006 Kia Sorento

1 Answer

I have aford windstar 1999 wiht a 3.1 engin my

There are fuses under the hood on passenger side and inside the van. Ours quit working and my husband figured out it was the switch.

Feb 19, 2010 | 1998 Ford Windstar

1 Answer

I need the power source for the remote mirror.. is it the green wire, on the switch?

I lost power to the mirrors broken wire, under the dash..
So I removed the switch panel on the door, and installed a jumper wire from the door lock circut, to power the mirrors. The green wire is the power supply wire for the remote mirror switch. My mirrors are back working and all is fine.

Oct 25, 2009 | 1990 Ford Thunderbird

1 Answer

There is no power to window switch is ok but won;nt roll down driver side or passanger side need to no how to get driver side window down antil i get fixed

Remove the door panel, and use two jumper wires to the window motor. One wire goes to a good, non-painted surface on the metal body of the van, for a good ground. The other wire goes to a 12 volt source. Touch the two wires of the window motor with the two jumper wires.

Tries to go up? Switch the jumper wires around, and try again.

Aug 10, 2009 | 1993 Ford Aerostar Extended

1 Answer

How do i fix an open SPOUT circut

replace the jumper in the connector for the shorting bar located near the ignition module.

Apr 02, 2009 | 1988 Ford Taurus

2 Answers

2001 isuzu rodeo driver side window is stuck down?

pullswitch drivers side power up brown and white and ground blue and red use jumper wires

Nov 26, 2008 | 2001 Isuzu Rodeo

Not finding what you are looking for?
2007 Chevrolet Optra 1.6 Logo

Related Topics:

100 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

85223 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides