What is the location of PCM...powertrain control module relay for a 1996 ford f-150 3515. ltr xlt 4x4?

The output speed sensor on a 2014 Ford F150 XLT is typically located on the transmission tailshaft or the rear of the transmission case. It is used to measure the rotational speed of the transmission output shaft and send a signal to the vehicle's powertrain control module (PCM) indicating the transmission gear ratio.
I would recommend checking the vehicle's service manual for a more specific location and a diagram of the sensor, as the location and installation may vary depending on the specific transmission model and options your Ford F150 XLT has.
The output speed sensor is typically a small, cylindrical sensor that is mounted to the transmission case. It is connected to the PCM via a harness and may be located near the transmission oil pan or near the output shaft.
If you're unsure of its location or have trouble finding it, a professional mechanic will be able to locate and diagnose any issues with the output speed sensor.

located on the drivers side by the brake power booster. it will have a lot of wires on a large plug and held to the PCM with a single bolt in the centre of the plug.

ive had this question before. It is under your center console where the cup holders are. up tworge the front, take the console off and you will see it a little square box silver in color with a wire harness plugged into it. hope i helped.

For Escape and Mariner, the Powertrain Control Module (PCM) is located behind the instrument panel (cowl), center to both driver and passenger sides (access from the engine compartment).

Fig. Powertrain Control Module (PCM) view

Hope this helps (remember to rate and comment this answer).

The radiator cooling fan relay in ford Tempo gl has been integrated into the CCRM (Constant Control Relay Module) this is the black box fixed to the left strut tower with the big cable harness on it.

This relay box is commanded by the PCM (Powertrain Control Module) it´s linked to every sensor in the car. (It's located behind the fuse panel next to the steering column.

The PCM supervises various conditions, including the signal that the ECT (Engine Coolant Temperature) sensor sends and power up the Fan Relay into CCRM to activate the Cooling Fan.
------------- This should help.Thanks.Helpmech.

The Ignition Control Module is integrated within the Powertrain Control Module or PCM on Both 3.0L & the 4.0L

Keep in mind the definitions:
* ECM = Electronic Control Module (prior 1995 computer, OBD1)
* PCM = Powertrain Control Module (1995 and newer, OBD2)

Ford Freestyle 2005 - Powertrain Control Module The PCM is located in the ine compartment, passenger side, mounted to the cowl. Removal & Installation procedure:

1. Retrieve the module configuration.
2. Remove the cowl panel grille.
3. Disconnect the 3 PCM electrical connectors.
4. Remove the bolt and the PCM.

To install:

1. Installation is the reverse of removal.

Hope helps (rememnber rated this).

Powertrain Control Module: Locations
The Powertrain Control Module (PCM) is located in the right-rear side of the engine compartment.

It does not have an ignition control module. The PCM (powertrain control module) fires the coil pack based on signal it recieves from the crankshaft position sensor and the camshaft position sensor.

Yes PCM (powertrain control module). is the standard name established by the EPA for all engine control computers, on Ford it also controls the trans shifting.