Requirements
The theft lock radio must be in "LOC" mode.
Procedure:
1. Turn the ignition ON (The radio should display "LOC")
2. Hold down the Radio Presets 2 and 3 buttons for six seconds
3. The radio display changes from LOC to a three-digit number. Write this number down. You now have fifteen seconds to complete the next step.
4. Press the AM/FM button
5. The radio display changes to another three-digit number. Write this number to the right of the first one.
6. You now have a six-digit number, the first three digits are from STEP 03 and the last three digits are form STEP 05
7. Call 1-800-537-5140
8. Press 1 then # (pound). You'll hear "Invalid Code, try again"
9. Press 139010 or 106010 or 206010 or 202107 then # (pound). You will be asked to enter your four or six digit code followed by *
10. Enter the number from STEP 6 then *
11. Listen to the four-digit number and write it down. It will be repeated twice
12. Turn the ignition ON (The radio displays LOC)
13. Use the MN and HR buttons to enter the code from STEP 11
14. Press the AM/FM button. The radio display changes to "SEC". Your radio is now "un-locked" and usable.
Dealership Codes
Troubleshooting
If you fail to enter the correct code eight times, the radio goes into INOP mode. You have to wait an hour with the ignnition on before the radio returns to LOC mode.
SOURCE: unlock antitheft code for 2004 chevy impala
Radios in the 2004 Impalas are tied to the vehicle's VIN through the computer, so it may be somewhat difficult to get the code. However, the following steps should work:
1. Press and hold the buttons for presets 1 & 4 (may be 2 & 3). The word "SEC" should show.
2. Press the "MIN" button. "000" should be displayed.
3. Press the "MIN" button again to have the second two numbers appear. Record these numbers.
4. Press the "HR" button for the first two numbers to appear. Record these numbers. -- Note: Your number sequence should be the numbers from the "HR" button followed by the numbers from the "MIN" button.
5. Call 1-800-537-5140. This will get you to the GM unlock code automated line. Ignore the prompt and enter "202108#". Next enter your code (remember, HR then MIN) followed by the * key. For example, 1234*. A 3 or 4 digit code will be given to you. If you get a code such as 0532, drop the zero when entering it into your radio.
6. Enter the code into the radio IAW the applicable manual.
SOURCE: radio unlock coed for chevy impala
• A module which communicates on the class 2 serial data circuit which supplies VIN information to the radio is replaced and not properly setup with the correct VIN information for that vehicle. The only way to unlock the radio is by using a scan tool.
SOURCE: changed radio in a 2008 chevy express van,now radio is locked
The codes for the radio are in the back of the owners manual.
SOURCE: how do you remove the old car battery on a 2008
SOURCE: I have a 2008 chevy impala. The car suddenly
ur vehicle is in limp mode[ a safe mode ] which will get u home trying not to cause any damage to engine --theirs a few reasons the vehicle will do this-low oil pressure-transmission problem-have vehicle scanned most auto stores such as auto zone / advanced auto [check ur local area]do this service for free the code gives u a start point towards resolving ur problem
956 views
Usually answered in minutes!
×