- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Thats code for a bad O-2 sensor. That can be caused by antifreeze getting into the exausht. Try clearing the code and putting in a can of Sea-Foam. I have had good success with that cleaning off the sensor.
Lean bank 1 and bank 2 , and throttle actuator system fault. Check reason for lean codes 1st, vacuum leak(s), air inlet boot and hoses, or low fuel pressure / clogged filter. Repair as needed then clear codes and recheck .
Have 2000 Buick Lesabre custom every time car gets up to operating temp. the engine misses going down the road , also let car sit and idle and it shuts off after about 2 minutes , my code reads PO171 system to lean bank 1, changed co2 censor, mass air flow censor, plug wires, and plugs.
The po300 is a misfire code.This means there is probably a plug,plug wire,ignition coil,or ignition module.Check the coil towers one at a time.These are know for corroding.If you find one that is corroded then replace the plug wire also.Po171 is a lean condition code.The po300 could be causing the po171.If you have not had a tune up Now would be a good time.Hope this helps.Good luck.
×