Usually held on by two bolts which are typically 13 or 14mm.sometimes it is easier to gain access from the wheel arch underneath.make sure you disconnect the battery before attempting to remove the cables attached to said starter.
SOURCE: scion xb wont start
Hi.. Yes i fix my problem by disconecting the neutral suitch and reconecting it ,,they get dirty with time and dont make contact ,Is a good idea to disconect and clean as many contacts as you can and put some special grease on them to prevent other problems ...
SOURCE: IAT location on my Scion XA
Your intake air temperature sensor is part of the MAF (mass airflow sensor) and located right off the air filter housing in the large tube going to the throttle body.Its held on with 2 screws and has a 5 wire electrical plug going to it.
SOURCE: my scion xa is shaking when idle
It might just be that the air filter holder is somehow knocking on a part of the engine. When I turned the holder away from the engine and then retightened the strap that holds the filter housing properly, I lose the "knocking"/"shaking" noise!
SOURCE: need to change spark plugs in my 2006 scion xa
try this article. Its pretty simple.
http://scionlife.com/forums/showthread.php?t=16364
SOURCE: what oil is used for an 06 scion xa?
Recommended oil is 5W30. You can go one step better by using a synthetic 5W30 oil. It may a bit more expensive than conventional oil but it will extend the life of your car's engine (as long as oil changes are done on a regular basis). Cheers!
Testimonial: "Great! Synthetic all the way "
2,092 views
Usually answered in minutes!
×