The manifold will be bolted to the front exhaust pipe as well. If all bolts are out of manifold, you need to be under car and disconnect front exhaust pipe to manifold bolts
SOURCE: Broken manifold bolts / manifold removal
Whatever it takes, but make sure you soak some penetrating oil oi wd40 on others to avoid any more being broken. Pulling the manifold is the safest and quickest way. With it out of the way, you'll have someting on the broken bots, now studs to work with. Always drill a broken stud or bolt clean through. Penetrating oil can work from both ends and a broken easy out can be driven in far enough to work arounf -Good Luck, force nothing, Tap stud and apply only stesdy even presure when extracting.
SOURCE: Need to remove Intake Manifold on 2002 PT Cruiser
Here are my photos what you need to open when replace plugs&wires:
http://www.ptcruiser.fi/ptgalleria/albums/userpics/10010/normal_tulppa1.jpg
http://www.ptcruiser.fi/ptgalleria/albums/userpics/10010/tulppa2.jpg
http://www.ptcruiser.fi/ptgalleria/albums/userpics/10010/tulppa3.jpg
SOURCE: removing starter on 1998 Mitsubishi Diamante
tap it a few timnes with a hammer.....it should loosen up then u decide .................. gl
SOURCE: I'm trying to remove my oil pan on a 2000
I am not sure, But there could be six more bolts to remove. They will be on the side of the pan, about half way up. three on each side. Sorry for guessing, I work on to many makes and models. Also the gaskets do hold the pan on tight sometimes. If there are no extra bolts then carefully pry it off.
96 views
Usually answered in minutes!
×