How do you get 2007 Saturn outlook. Out of assembly mode and production mode for airbag

It appears to be a known issue on Saturn. Some say the alarm, some say the button. According to this, disconnecting the battery for a few hours will fix it.

http://www.saturnfans.com/forums/showthread.php?t=131565

https://www.google.com/search?q=2008+Saturn+Outlook.+My+hazard+lights+won%27t+turn+off

You can also try pulling the Body Control Module fuse first.

Saturn Outlook (2006-2010) fuses and relays

https://fuse-box.info > saturn > saturn-outlook-2006-20...
Fuse box diagram - Interior fuse box diagram: Saturn Outlook (2006, 2007, 2008, 2009,. Ad. Assignment of the fuses in the Passenger Compartment ...

..

Air Bag Light Flashing, How to diagnose and fix - YouTube

? 4:30
https://www.youtube.com/watch?v=FiO9wUb9FV4
Jan 21, 2014 - Uploaded by ChrisFix
Airbag light on or airbag light flashing? ... My 05 Elantra's air bag light flashes 5 or 6 times, then turns off and the Passenger Airbag Off light ...Missing: saturn ‎vue

50 Complaints: 2007 Saturn Vue Air Bags Problems

www.carcomplaints.com/Saturn/Vue/2007/seat...air_bags/air_bags.shtml
The 2007 Saturn Vue has 50 NHTSA complaints for the air bags at 63389 miles ... I started my car and the drive side air bag light came on no blinking just on.

Hi Carol , your going to have to remove the headlamp assembly to replace the bulb !


Remove the headlamp assembly. Refer to Headlamp Replacement.



1



Headlamp Bulb Accessory Covers (Qty: 2)



2



Headlamp Bulb Assembly (High Beam)




Caution: Refer to Halogen Bulb Caution in the Preface section.




Tip

Disconnect the electrical connectors and remove the bulbs.



3



Headlamp Bulb Assembly (Low Beam)


Callout

Component Name

Preliminary Procedure

Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement .




Headlamp Assembly Bolt (Qty: 4)

Notice: Refer to Fastener Notice in the Preface section.

Tighten

6 N?·m (53 lb in)







2





Headlamp Fascia Brace Fender Reinforcement Bolt




Tighten

6 N?·m (53 lb in)







3





Headlamp Cam Adjuster




Procedure

Set the headlamp adjusters at the nominal setting of 6 turns off fully seated.







4





Headlamp Cam Locking Nut







5





Headlamp Assembly




Tip

Disconnect the electrical harness as the headlamp assembly is being removed from the vehicle.

Here's a link to your sensor. Repair Guides Coolant Temperature Sensor Removal Installation AutoZone... Here's what it look's like. Coolant Temperature Sensor 2007 Saturn Outlook 2WD 6 Cylinders 7 3 6L...

GM has issued a fix campaign for this problem. The 08 Saturn outlook is included if your last 8 VIN is from 8J162227 through 8J66442. See this post
Airbag Light on Service Airbag Message GM Ricks Free Auto Repair Advice

No matter who does the job you will have to reprogram everything. Some parts stores sell a product that uses a 9 volt battery and plugs into the cigarette lighter, but in my experience they almost never work.

bad connector under seat in the front, same thing is happening to ours, try not to move the seat

To replace a headlamp on a Saturn Outlook you need to access it via the wheel well. So jack up the car and remove the front tire. You'll see a collection of phillips head trim screws and plastic snap in panel connectors holding the plastic wheel well in place. Remove the screws and snap in connectors. To remove the connectors, pry the center button up with a small screwdriver. One it's up the whole connector should pop free.
Remove the wheel well.
Turn the black plastic cap on the back of the headlamp assembly 1/4 turn counterclockwise and it should come free. Now the lamp wiring and connector should be visible. Turn the lamp ~90 degrees and it should pop free. Test the bulb. More people have problems with the wiring connection and the bulb is usually OK.

I have an Outlook that was burning through bulbs. The best way to change it, is to remove the inner fender well and it gives you easy access to the rear of the headlight assembly. It takes about 2 min and no skinny hands required.

I agree with the other fae90. Tried to remove the light assy, then I read his post and did it inside 20 minutes. Took me longer to put it all back again