SOURCE: clutch pedal not returning to position
Under the dash look to see if there is a spring attached to the petal or maybe under the hood. Or you might have something getting in the was of the petal arm. Good Luck and PEACE
SOURCE: clutch pedal is very heavy to push down
If the clutch in your car is hydralic there is no way to adjust that type of clutch. That you describe the clutch as being hard to push and that you have to have the clutch "right down on the floor to engage a gear" is an indication that the clutch is worn and needs to be replaced. If the clutch in your car is pushed by a cable, the cable might be adjustable and if that is the case you might get a few more months of use from the car, but the fix is still the same, you will need to get a new clutch put in your car.
SOURCE: 1997 hyandai accent gt clutch problem
hi considering age of car and that you have no leaks on hydraulics? may i suggest you try bleeding the clutch to rid of old fluid a couple of pumps may be suffice ? b/fluid does absorb moisture and heat over time hence recommendation tat fluid be changed at period specified in handbooks ie 12 monthly ?
SOURCE: no pressure clutch pedal goes straight to the floor 1988 holden r
If hydraulic actuated mechanism, loss of fluid, defective master cylinder or slave cylinder at the clutch. Missing pin or other part between slave cylinder and clutch arm. Loose or broken slave cylinder mounting. Missing pin or broken part between pedal and master cylinder. If mechanical linkage, look for broken components or missing pins at moving joints. If you tried to shift into gear with engine running, you may have damaged the transmission gears.
SOURCE: the clutch pedal sticks down when trying to engage
YOU DO NEED A NEW DISC AND MOST LIKELY A MASTER AND SLAVE HYDRAULIC CLUTCH CYLINDERS, THE STICKING MAY BE DUE TO OVER TRAVEL DUE TO THE WORN OUT DISK.
37 views
Usually answered in minutes!
×