How to remove ignition switch
SOURCE: 1999 Acura CL - Gas Filter
4cyl and 6cyl are both located on the firewall, driver side under the hood
SOURCE: Find oil filter in engine of acura CL
back side of block under intake if its a 2.2 or a 2.3 if its a 3.0 its on the passenger side of engine bay if you turn the wheel you will be looking at it
SOURCE: Lost code for my 1998 acura cl
You have to call the dealer and give them your vin# they tell You P.S. DO NOT TRY AND PUT IN A CODE THREE STRIKES AND YOU OUT. BUT I CAN FIX THAT TOO ONCE YOU GET YOUR CODE . I hope that helped.
SOURCE: neeed to find out where the startr relay switch is
# 1 IS RIGHT, WHAT IS THE PROBLEM? IF YOU JUMPER TO THE SOLENOID ON THE STARTER, YOU WILL SEE IF THE "STARTER" WORKS.
OF COURSE, IT COULD BE THE BATTERY, OR CONNECTION (CABLES) OR GROUND.
IT'S AN AUTOMATIC, IT COULD BE THE PARK/NEUTRAL POSITION SWITCH AND IT COULD BE THE BRAKE/CLUTCH SAFETY SWITCH ON A MANUAL.
THE RELAY WOULD BE THE CAUSE IF IT WON'T START, BUT THE STARTER TURNS IT OVER.
THERE IS A ''CUT RELAY" NEXT TO THE MAIN RELAY WITH A SIMILAR GROUPING OF WIRES.
SOURCE: Adjust idle on 97' Acura cl 2.2
Your idle should pretty much be set by the computer and shouldn't change to much unless some repairs have been or you have another problem. In any case below are the instructions on seting the idle. Also below I marked which fuse you will need to pull out for about 10 seconds in order to reset the computer. Make sure that if your radio has a security code that you have it before you pull this fuse as you will have to reset it. Hope this helps.
574 views
Usually answered in minutes!
×