Its in the fsm book and at alldata.com
click 93 YJ here.
http://www.jeep4x4center.com/knowledge-base/index.htm?utm_source=cj#service
then click engine.
posted 100s of times, ever search?, nah,.
SOURCE: valve cover gasket replacement
If I remember correctly, the gasket is part of the valve cover.
SOURCE: 1992 Jeep Wrangler heater not blowing hot air
How often has the coolant been changed? My only guess is that it hasn't and the hoses and the heater core are plugged up with goo and a flush is needed
SOURCE: 1992 jeep wrangler with faulty acceleration. It
It is possibly the O2 sensor. I had some issues with early 90's 4.0 liters where the O2 sensor would stick rich under heavy acceleration and would cause it to lean out and bog down. It felt like a rochester four barrel flat spot on an old chevy. I hope this helps.
SOURCE: Dont know were to put in new transmission oil on a 1992 Jeep Wrangler
the plug of the transmission of 1992 jeep is under the transmission case .
SOURCE: How do I change the freon from R-12 to R-134A on a
no parts need to be changed the original expansion valve will work fine but the receiver dryer should be replaced and the system flushed with AC system flush and compressed air (condensor and evaporator), then the system must be evacuated with an AC vacuum pump for at least 15 minutes, the main thing to remember is that it requires only 85% as much R134 as R12 when you recharge the system, the conversion kits are avail any good auto parts store for about $35, u will need three cans of R134, charge the system until the low side port reading is around 28-32 PSI, at that point the system is full..
Testimonial: "excellent advice. Simple and to the point. Easy to understand"
195 views
Usually answered in minutes!
×