Is there a special fuse for my front power window and mirrors on my 2008 dodge nitro

There is no fuse, so they are a function of the integrated power module. You can check the switch, but you probably need an auto electrician.

Fuse Box Diagram Dodge Caliber (2006-2012)

https://fuse-box.info > dodge > dodge-caliber-2006-20...

2007, 2008 - In this article, you will find fuse box diagrams of Dodge Caliber 2006, 2007, 2008, 2009, 2010, 2011 and 2012, get information about the ...

..

Open the front doors and look on the sides of the dash for a pop off panel

DODGE NITRO SERVICE REPAIR MANUAL 2007 2008 DOWNLOAD

for the easy solution download the pdf file

LOOK IN YOUR MANUEL OR TAKE TO YOUR DODGE DEALER

You have to start with removing the door panel as follows:

CAUTION: Pay close attention to the plastic hook attachment points on the inside of the door trim panel. Make sure that every hook is correctly positioned to the door when installing the trim panel. Damage to the trim panel will occur if the hooks in the door panel are not properly positioned to the door during installation. 1. Connect the electrical connectors and install the power window switch. 2. Carefully install the door trim panel (4) to the door (1) by lifting upward and over the door lock into the trim panel then attach the trim panel to the carrier plate attachment points. 3. Install the screws (2) and the cap screw covers (3) to the front door trim (4). 4. Install the fastener (5) at the handle area of the front door trim (4) and tighten screw to 5.5 Nm (50 in. lbs.). 5. Install the door handle trim bezel (6).

1. Install the mirror assembly (1). 2. Install the three nuts (2) and tighten to 7 Nm (65 in. lbs.). 3. Connect the electrical connector (3). 4. Install the trim panel

Dodge Grand Caravan No Power Window No Power Locks CAN Trouble

with a test light and the ignition key on test these two fuses. on the little metal that sticks out on the fuse on both sides please test both sides.

You can access the oil filter easily from underneath next to the front, driver-side wheel at the front of the engine. There is clear access to the filter there.

They want that much because they have to replace the valance and paint it, the one with fog lights has a special brackets for them, Check to see if there is a nut on the back side of the fog light if there is you can just remove it, the fog lamps cost $110.00 each so thats 220 dollars and they use a special light switch that costs $60.00 thats why it's so much, plus have to wire it in if the Dodge did not come with the lights it may not have the wires for the harness to run the lights. So you will have to run a new relay intothe relay box switch and wires and a fuse to do it, even if you buy the factory lights and add a switch and relay your talking about $300.00

You can access the oil filter easily from underneath next to the front, driver-side wheel at the front of the engine. There is clear access to the filter there.

For more info on Dodge Nitro, visit the forum at
http://www.dodge-nitro.com/dodge-nitro/