WHERE IS THE LOCATION OF THE MAP SENSOR IN JEEP GRAND CHEROKEE 2000. THANKS

You should be able to order a manual at an auto parts store or your local bookstore. It is worth checking the library to see if they have a copy.

very good, you state the engine, in car.
a WJ Jeep
you can look any time here.
http://www.jeep4x4center.com/knowledge-base/index.htm?utm_source=cj#service
fuel system and delevery
pdf page 44 actual (FSM 14-44)
bingo

It is a 'under 5 volts' error to the map sensor.

Here you go.

Check this Jeep information about your engines...
3.7L -The Manifold Absolute Pressure (MAP) sensor is mounted into the front of the intake manifold with 2 screws.
4.0L - On the 4.0L six-cylinder engine the MAP sensor is mounted to the engine throttle body. On the 4.7L V-8 engine the MAP sensor is mounted to front of the intake manifold.
4.7L - The MAP sensor is located on the front of the intake manifold. An O-ring seals the sensor to the intake manifold.

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

donde se encuentra el map sensor para un jeep grand cherokee limited 2000

ITS INTHE INTAKE MANIFOLD MAP STANDS FOR MANIFOLD ABSOLITE PRESSURE THE SERVICE CODE SHOULD BE PO1106 HIGH VOLTAGE OR PO1107 LOW VOLTAGE IF YOU DON;T HAVE THESE CODES THEN ITS PROBELY NOT THE MAP SENSOR REPLACING COMPOUNETS SHOULD BE THE LAST STEP FORM A PLAIN IM NOT SAYING MAP IS NOT THE PROBLEM BUT BLINDLY REPLACEING SENSORS CAN BE A COSELY MISTAKE GET CODES

Both are attached to the throttle body. Tps is on the other end of the throttle plate shaft opposite the linkage, MAP is on the side...has small vacuum hose underneath and is flat, about 3" long. The other item on the TB is the idle air motor, next to tps.

Go half way between the air cleaner box and the "carburetor". Up the 4" black air pipe, a wire harness plug plugs into the MAP sensor there. Also called MAS air flow sensor.

if you mean speed sensor it is located on reductor where shaft comes out to rear dif. if you mean rpm sensor, it is located on top of transmition screwed vith two bolts in cilinder block.
marko