There is a crown that goes round the ignition you did plug this part back in and put the original on back onto the steering column, as this part is linked to your key. if not replace to the original crown.
Changed steering column and ignition. Will start but wont stay running
yes it will do that its looking for the key. it reads the key around every 30 seconds while ignition is on.
these are were the wires are and go.
sensor in the housing reads the keys info.
×
SOURCE: pass lock problems
Your Passlock may need to relearn the ignition keys, if the
ignition lock has gone bad like my in-laws Grand Am Gt, here is what i
did so they will not get stranded any more. Buy a Passlock by pass
module for around $70.00. You can order one from GMPASSLOCK.COM in the
mean time try resetting the Passlock. Good luck
Ignition keys relearn takes about 30 min to do. 30-Minute Learn Procedure
1.) Turn ON the ignition, with the engine OFF.
2.) Attempt to start the engine, then release the key to ON; the vehicle will not start.
3.) Observe the SECURITY tell tale light. After approximately 10 minutes, the light will turn OFF.
4.) Turn OFF the ignition switch, and wait 5 seconds.
5.) Repeat steps 1 through 4 - two more times - for a total of 3 cycles of 10 minutes. 3x10 = 30 minutes.
The vehicle is now ready to relearn the Passlock
Sensor Data Code and/or passwords on the next ignition switch turn from
OFF to CRANK Important: Turn the Ignition Switch OFF. The vehicle
learns the Passlock Sensor Data Code and/or password on the
next ignition switch transition from OFF to CRANK. You must turn the
ignition OFF before attempting to start the vehicle.
6.) Start the engine. The vehicle has now learned the Passlock Sensor Data Code and/or password.
7.) With a scan tool, clear any DTCs if needed. History DTCs will self clear after 100 ignition cycles.
Without a scan tool you may have momentary starter interruptions while history clears itself.
160 views
Usually answered in minutes!
×