Where is the map sensor at on a 2000 dodge durango SLT with the 5.9L motor

SOURCE: 2000 Dodge Durango SLT 4wd - turn signal is

these vehicles do not have flashers, it is the turn signal switch in the steering column it is called a multi-function switch!
That's where your problem is!!

SOURCE: What Happens When a Map Sensor Goes Bad on 2001

Manifold Absolute Pressure sensor controls fuel delivery and ignition timing, the pressure in the intake manifold will vary due to stress or work load, the MAP sensor monitors this, reporting to the computer. Good luck.

SOURCE: location of air pollin dust filter on a 2000 dodge durango slt?

The dodge Durango does not have a cabin air filter (pollen/dust filter) The only Dodge to have an dealer option to include one is the Dodge Caravan

Greg Bernett

• 2993 Answers
• Posted on Apr 23, 2010

SOURCE: How hard is it to replace the MAP sensor on a 2001 dodge durango?

VERY SIMPLE!!!!!

4.7L The MAP sensor is located on the front of the intake manifold. An O-ring seals the sensor to the intake manifold.

1. Disconnect electrical connector at sensor.
   
2. Clean area around MAP sensor.
   
3. Remove 2 sensor mounting bolts.
   
4. Remove MAP sensor from intake manifold.
   

1. Clean MAP sensor mounting hole at intake manifold.
   
2. Check MAP sensor O-ring seal for cuts or tears.
   
3. Position sensor into manifold.
   
4. Install MAP sensor mounting bolts (screws). Tighten screws to 3 Nm (25 inch lbs..) torque.
   
5. Connect electrical connector.
   

Testimonial: "Awesome....sounds easy enough to do it on my own and same some cash...Thanks!"

SOURCE: I am getting the following

They all point to your Transmission Governor and Gears. You will need to take your vechile to a Transmission Shop to diagnose the problem