Check that you installed the bearings /bushes in the swing arm correctly. check that they may be inserted from the inside to prevent metal to metal contact during operation of the arm with the mount
SOURCE: Vt250F Swing arm bearings need replacing
You need to tap the old races out with a large hammer and a drift. A steel chisel works, a punch with a flat end works better. Position the punch or chisel on the visible edge from the opposite side and hit it firmly. Move your device to the opposite edge and hit it again. You don't want to drive only one side out, twisting the race. It needs to be driven fairly evenly, close to straight out. Rarely, you have to cut the race out, if you must do that I would use a rotary tool with a cutting disc.
SOURCE: Will 190/0x17 tire clear the chain, swing arm, etc. on a GSF 1200
depends on the make of tyre whether u will have clearance or not. U should b aware that 190s r not made to run on 5.5 inch rims and doing so stuffs up the tyres profile and will adversely effect the handling.
SOURCE: rear swing arm on nsr 125
you will be able to purchase one from a honda dealership, honda motor cycle dealer. if they dont have one in stock they should be able to order you one from the honda factory.
SOURCE: yamaha diversion swing arm and bearings
You can check the manual but its in french..
http://safemanuals.com/user-guide-instructions-owner-manual/YAMAHA/XJ900S-2000-_F
Did you put new seals and bearings in? Have you any parts left over?
Get back to me if you need more help with this.
SOURCE: how to remove swing arm bearings on a suzuki rm 80
need a bearing removal tool, pick one up @ your dealer
If you need further help, I’m available over the phone at https://www.6ya.com/expert/michael_00678fd4800d19c5
82 views
Usually answered in minutes!
×