Nothing
Here are some code definitions: I am also including a link to a forum discussion of the problem. The forums can be very helpful.
P0745 Pressure Control Solenoid Malfunction
P0745 OBD II Trouble Code
2000 LS transmission P0745
Here is what ford service info says
P0745
PCA
PCA solenoid or circuit fault
PCA functional fault - low pressure.
Incorrect shift pattern indicating mechanical or hydraulic failure of the transmission. May turn on MIL.
PINPOINT TEST D: PRESSURE CONTROL (PC) SOLENOIDS (PCA, PCB, PCC)
NOTE: Refer to the Transmission Vehicle Harness Connector illustration preceding these pinpoint tests.
NOTE: Read and record all DTCs. All digital TR sensor and VSS DTCs must be repaired before entering output state control (OSC).
Test Step
Result / Action to Take
D1 ELECTRONIC DIAGNOSTICS
Yes
REMAIN in Trans-Bench Mode. GO to D2 .
No
REPEAT procedure to enter Trans-Bench Mode. If vehicle did not enter OSC, REFER to Powertrain Control/Emissions Diagnosis (PC/ED) manual for diagnosis of PCM or NGS.
D2 SOLENOID FUNCTIONAL TEST
Yes
CLEAR DTCs.
No
GO to D3 .
D3 CHECK FOR BATTERY VOLTAGE
Yes
GO to D4 .
No
REPAIR the circuit. TEST the system for normal operation.
D4 ELECTRICAL SIGNAL CHECK
Yes
GO to D5 .
No
CHECK for open or short circuit in harness or PCM.
D5 CHECK SOLENOID RESISTANCE AT SOLENOID
Yes
GO to D6 .
No
INSTALL a new solenoid body assembly.
D6 CHECK SOLENOID FOR SHORT TO GROUND
Yes
INSTALL a new solenoid body assembly. TEST the system for normal operation.
No
REFER to Diagnosis By Symptom in this section for diagnosis of pressure concerns. TEST the system for normal operation.
Do you have a good scan tool ? more then likely the solenoid is bad !
SOURCE: 2002 LS: aHow do I fill radiator in my V8 Lincoln LS...
First- to drain ,you can reach the drain valve,from the pass side,if you lay on the ground and reach up to the radiator. You do not even have to raise the vehicle up
Second- mix Yellow GO5 Coolant about 50/50 or 60/40. Do not use Green in a Ford or Orange GM
To Fill- Remove the front two plastic screw type buttons,from the engine cover
-Remove the cover
The radiator cap is on the front of engine,on top,it is plastic
Remove cap and that is your fill point
Run engine to warm and get thermostat open,as you would with any vehicle
Top off coolant,replace cap
VERY IMPORTANT-next to the Power Brake Booster,and just under it,is a BLEEDER HOSE;to let air out of system. Turn screw slot ,only a little,DO NOT REMOVE SCREW. When coolant runs out close.
Fill-Degas Bottle,to full line,with coolant.
Check the next couple days on resevoir level ( Degas Bottle)
SOURCE: how can i find the keypad code on my 2004 lincoln
In the grey folder with your owners manual,is a white card with the factory code,for the keyless entry keypad. It also, tells you, how to put in your own code
SOURCE: diagram for a 2000 lincoln ls V8
Your best ,to cut the old belt,to remove.
You can use a long handle 1/2" drive ratchet, on the belt tensioner.
The only pic is in the shop manual.
Wear long sleeves and arm protector sleeves on top. the fan housing is sharp and a tight fit. You will be there a couple hours.
Draw a picture before you start, and you won't need a diagram
SOURCE: where is the coil pack located on lincoln ls v8 7
Driver side valve cover
7mm socket to remove coil covers and coil
1 thru 4 pass side
5 thru 8 drivers side
Front to back
SOURCE: engine diagram showing location of crank sensor on
Hi, be sure to oil the o-ring and twist the new sensor as you push it in.. Please let me know if you have more questions, and thanks for using FixYa.
606 views
Usually answered in minutes!
×