Nothing
SOURCE: location of ECT sensor
when you open the hood take your right hand and follow the upper rad hose down to the eng. when it stops thats the themostat housing the ect sensor is screwed into that housing there are two sensor one will have one wire and the other will have two you want the two wire one. be carful remove the conector the like to break good luck kdc744
SOURCE: Cam Shaft Position Sensor 1998 Saturn SL
Have a look at this link, scroll to your engine & click on picture to expand for better view.
http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528017e904
SOURCE: I need to know where the crankshaft sensor on a
the crank sensor is on the back of the engine above/behind the starter Two wires green connector
The sensor should be located to the front of the engine block to the right of the oil filter. It's only held in by one bolt and is a quick replacement. You'll need to be under the vehicle for this and it would help to jack the car up a bit to better move about. Remember to use jack stands as a fall may not kill you but will smoosh you pretty good. Usual cause is not running or jerkyness if running or from a cold start it will run for a few minutes then cut off. Crank it all you want it won't turn on. When it finally does it will only run for a bit. I suggest prior to installing a new sensor (electric parts cannot be returned) when the car dies pull a spark plug. Ground the housing to the car and crank the engine. If you have spark your CPS is fine so start looking at fuel pumps! If you don't have spark do the irish jig because your fix is simple! Hope this helps.
SOURCE: Saturn SL-1 Cam position sensor problem
replace it before you end up spending more than you want to $$$$,regee
1,954 views
Usually answered in minutes!
×