Its a short bell like sound like a warning from right side of the dash just a few seconds.
SOURCE: need to remove the heater switch on 2005 ford explorer, how ?
You need to replace the temp control actuator. It gear is stripped in it.
SOURCE: how to install passenger side view mirror Ford
On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door
SOURCE: i have a 2004 ford explorer the heater only puts
It can't. The problem you describe sounds like your blend door has broken, to access it you have to remove the dash completely to access the environmental station, you may be able to open the environmental station to replace the blend door after that, however you may have to remove the environmental station as well, which means you will have to disconnect the water lines to the heater and the a/c also. Verify your door problem by going to the center of the dash at the bottom find the cover panel and remove it, look for a small white square box, this is the stepping motor that moves the blend door, take it off and plug it into its wiring harness, rotate your temp controls and see if it moves, if so use a inspection mirror and look up at the door and see if the drive end has broken off. Hope this helps, let me know
SOURCE: my 2002 ford explorer wont blow any air out of the vents...
It sounds like blower motor has failed. Motor is located behind glove box on lower part of heater box.
250 views
Usually answered in minutes!
×