Everything works but after I get in the car the control center light blinks consistant
SOURCE: trouble starting....
check battery connection. make sure terminals are clean. and make sure the terminals are not loose when connected
SOURCE: My car alarm is blinking
You need to first look under the drivers side dash area near the hood release/fuse panel area and see if there is a valet switch. The switch will look like a little toggle or a push switch. After you locate it, turn the ignition switch to the on position(dont start it) and flick the valet to the opposite position it is in now. If done correctly in most cases the red system light will stay a constant instead of off or blinking indicating you are in valet mode. Next try to start the engine. If this doesnt work you need to remove the alarm system and repair the ignition switch wiring or replace the electrical portion of the ignition switch. The aftermarket alarm cuts into the ignition switch wires and bypasses the start circuit through the alarm module. When disarmed the alarm completes the circuit and allows the car to start. Good luck hope this helps and please rate this.
SOURCE: Viper Alarm System problem
Look for a push button under the dash, should be black, turn key on and hit button.. should go into "valet mode".. hopefully you will be all set...
SOURCE: Car alarm stopped working.. Car wont start
the jetta has a faulty alarm system from the factory i have been working on one in my shop. the alarm moddule is inside the dash behind the light switch and has a 10 pin connector and a 6 pin connector. this can be bypassed if you disconnect both connectors and jump the two large wire on the 6 pin connectors, these wires operate your starter. the car will start and run but your alarm will no longer be active. the door locks and everthing else will still work. the only issue i am having is the factory radio isn't working because it is controlled by the alarm. but worse case scenario i can use an aftermarket radio if need be.
SOURCE: I need help to reset the car alarm. There is no
on your dash there will be a two button switch. one with a star and one blank. press the star twice then the blank and your light should go solid. you"ll be in valet mode. if this works you can actually program a remote using the user guides on the clifford web site. (note you may also try it with your ignition in th eon mode but don't turn the car over.)
290 views
Usually answered in minutes!
×