This is detailed on page 317 in the manual. The manual is available here from Honda:
http://techinfo.honda.com/rjanisis/pubs/OM/AH/A9V0303OM/enu/PI0303OM.pdf
It is very straightforward to replace the headlights. Do not touch the new bulb's glass with your hands as the oil can shorten the life of the bulb. Just hold the bulb by its base.
If you can reach it from behind you simply turn it and pull it out. Snap out the dead bulb and replace. If you can not physically get behind the lens then you need to remove the lens to gain access to your bulb. That is easy to do. There should be two or three bolts/screws holding the assembly in. Remove them and the lens will pull out. After pulling it out you can access your bulbs. Do no touch the surface of the new bulb on install. Your finger oils will shorten the life of the lamp
SOURCE: radio code for 2003 honda pilot, and reset for maintanence light
There is a little fuse box to the left of the steering wheel with a cover over it. When you take off the cover on the under side of the cover there is a big number (like big font size) printed on a piece of paper. It like 5 or 6 digits long and obviosly numbers that can go into your stereo, like 1-6. If you type it in and it works it will make a beeping sound.
If that doesnt help, call your local Honda dealership and get the code from them. You can also obtain a user manual. All the needed info can be found on this page:
http://automobiles.honda.com/information/owner-resources.aspx
SOURCE: 2003 honda crv. how do i remove light bulb cover
you have to go under the bumper and and look behind then look for the back of the lightbalb connection. if you see that. pull on it carefully. if rusted, spray some wd forty on it but make sure you dont get the wires with the wd forty
SOURCE: 2003 honda pilot right rear door lock does not
if all others are working properly you are most likely having a problem with the door lock actuator in that door
SOURCE: 2005 Honda Pilot...1/2 dome light works using
It's the ground wiring in the module. I wired ground from one side of module to the other and now it works.
SOURCE: how do you replace a map light bulb in a 2006
take a small screw driver and place it between the white lense and caseing carefully pry the lens of there should be eather 2 or 4 prongs holding it in place ounce the lense is off pull the bulb out (just pull) then install new bulb replace lense and you are done good luck cj
150 views
Usually answered in minutes!
×