Change in cabin air filter in 2011 Nissan rouge
If you mean rogue, there should be a cover for your in cabin filter right by the gas pedal to the right towards the fire wall. It should be fairly skinny in size and just unclog the cover and pull out existing filter. To replace, just reverse the step. Quick tip is to pinch filter in the middle like a bow tie to help fit back in easier. Hope this helps you out and GL
SOURCE: How to replace cabin air filter nissan sentra 2002?
I think it is behind the glove box. you have to take the glove box out. sometimes the sides push together and it falls to the floor. it is behind there.
SOURCE: trying to change the cabin air filter
1. Open glove box
2. Unhook elastic retainer on right side
3. Locate the two "stop tabs", one on the upper left and the other on the right side. Push both to the left to clear their stops and the glove box will swing down, allowing access to the filter cover.
SOURCE: how to change 2006 Nissan Pathfinder microcabin filter
To change the cabin air filters (there are two, that are in same location), you first have to remove the glovebox. The glovebox itself will not come off. You have to get a phillips head screwdriver to remove the 5 screws. With the glovebox closed, locate the two screws underneath and remove, one on each side. Next open the glovebox, remove the two screws at the top. The fifth screw is on the right behind the plastic molding. Pull back on the top of the lower piece of molding until the bracket pops out. The piece of plastic located just above that piece needs to be pulled out. No need to take it out all the way, just enough to get to the screw. Once removed, with the glovebox open take the fuse panel cover to the right off to allow you better grip. Pull both sides evenly until glove box pops out.
Get a flashlight and shine it on the right side behind where the glovebox was. There is a small plastic cover about 1 inch tall by 5 inches long. It is clipped in place. Push up on the plastic clip with your thumb while pulling out and down with your other finger/fingers. Behind this is one filter. Remove it best you can. Be careful, mine had dead bee's/wasps/dust/dirt/pinestraw/etc. After removing the first, you will notice a second one to the right of that. Slide that one to the left and remove the same way as the first. Look at those filters when you remove and take note the direction of AIR FLOW ^marking. Before replacing with the new ones, vacuum out inside where the filters go as best you can to remove all that crud that fell off of the old filters when removed.
Reinstallation is the reverse of how you removed. I hope this helps all my fellow Pathfinders out there.
SOURCE: I need to replace my Nissan Quest 2007 in cabin micro filter
I'm going to send you exploded view of the glove box and the in cabin micro filter cover illustration. Remove the two upper screws on the glove box and carefully pry metal clips loose.
Disconnect glove box lamp electrical connector. Do not let glove box assembly hang from glove box lamp harness.
Remove three lower screws and remove damper clip from glove box door. Separate glove box housing and passenger instrument lower panel.
Remove three screws and remove in cabin micro filter cover.
Remove in cabin micro filters from front heater and cooling unit assembly.
Note When installing two new in cabin micro filters ensure that the filters are facing in the direction indicated by the direction arrow for the airflow. Direction arrow is printed on side of in cabin micro filters.
Install in cabin micro filter cover. Reinstall glove box.
Testimonial: "Finaly I found the air flow door with three screws and removed it. The filter will need replacement soon. It is been replaced one time at the dealer."
SOURCE: I have a 2008 Nissan Sentra and want to change
Carefully remove the plastic panel from the left side of the center console next to the accelerator pedal. That will expose the heater coil and lower duct. Next to the accelerator pedal there is a long, slender cover that is removable. Pull down gently on the bottom to unsnap, rotate out, and remove from top hinge. The filter is there. Reverse operation to restore console.
563 views
Usually answered in minutes!
×