This is a common problem in these model years of Chrysler vehicles, Be patient and you can easily DIY. The mechanism consists of a motor and two cable/two guide rail assembly. The guide rails hold the window onto the cable with a clip on each rail. It is better to buy the whole assembly new rather than just replacing a bad motor or just the guide rail/cable assembly. I have been burned just replacing one or the other only to learn when popping open the cable spool that 1) cable is shredded or 2) it ain't easy winding the cable back up as tight as the mfr had it and the window won't roll up with the same speed as the other one. You will need a Torx set... a 25 or 30 size if I remember will remove the guide rail bolts. Some models have the motors riveting on with soft aluminum rivets. Just drill them out... like butter. Others have torx bolts on them with the nuts encapsulated inside a grommet. Put your hand behind and inside the door panel to hold them with your hand when removing the torx bolts. Their are two holes on the inside of the door panel... one guide rail is extracted through one of them, and the other one through it's own hole. Push the window up first, have an assistance hold it halfway up for you so you can see and pull the guide rail release clips with needle-nose pliers. Push the window up all the way and tape it using a good tape around the door sill at the top. Then you can start removing/replacing the motor and guide rails. When your done, plug the wiring harness back in and raise the guide rail half way up using the motor and then unplug the harness again. Have your trusty assistant lower the window down gently, insuring it's inside the groove and stopped by the guide rail clip assembly. Insert the clips back in and test your work before re-assembling your door panel. Crutchfield makes new door panel liner, if yours is crispy. A heat gun sometimes help remove them more intact. Good luck!
SOURCE: 1999 Dodge Durango driver side window does not roll up nor down.
Remove the door panel and find the window motor Unplug it and using a separate car battery run cables directly to the window motor When you switch the polarity the motor will either bring the window up or down or if noting happened change the window motor and window regulator assembly.
SOURCE: loacte the fuel filter on 2000 dodge durango 4.7 liter v8
if i am not mistaken the fuel filter is built into the fuel pump. which requires you to drop the tank and replace both.
SOURCE: My windows stopped working they wont roll up in my
If they all stopped working at the same time, I would bet the fuse would be a good place to start.
SOURCE: 2007 Dodge Durango power window switches don't work
The master switch is bad, Just replace it and your fine
SOURCE: 2000 dodge durango driver side window problem
I have had to replace three of the four window power regulators in my 2000 Durango. They just seem to stop working within a year or two of each other.
311 views
Usually answered in minutes!
×