SOURCE: Lower Control Arm Bushing replacement
Hi,
I just did this job on my 98 regal, and I own the service manuals also. The lower control arm bushing that usually goes, is the front one. The rear one doesn't usually go, it is horizontally mounted. The front one for some reason is vertical. The control arm must be removed, and put in a vise. The front bushings outer metal sleeve, must be driven out with a chisel. It comes out easily. The new bushing can be tapped in with a hammer. Hope this helps!
JOEVETTE
SOURCE: Can you replace the lower ball joints in the control arms
You can replace them seperately,but they need pressed out and in. Other methods of removing and installing likely will damage control arm.
SOURCE: 95 explorer lower control arm replace
No the torsion bar if you look at it where it goes to the under carriage it will have a bolt for tension on each side. Are you tring to replace the bushings for the torsion bar? If so answer back.
SOURCE: Can't remove the lower control arm front bushing bolt
try to releive pressure by having it on stand also try another bolt from otherside or if you can get a vice grip on the shaft without stripping the threads and hit it with a hammer also wiggle control arm up and down while you do this
93 views
Usually answered in minutes!
×