97 dodge dakota 5.2 motor 4x4 new transmission sometimes it wont come out of first can not cut overdrive off first time u take off after cranking can not go over half throttle or motor will bog down
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
? 8:10
https://www.youtube.com/watch?v=a-rfAd0YLg0
Jun 29, 2014 - Uploaded by AJ Pierce
In this video, I will show you how I fixed my 1992 Dodge Dakotanot starting. ... Engine cranks but won't start - Duration: 18:30. jimthecarguy ...
Engine Will Not Start Due to Blown Door Lock Fuse on Dodge Dakota ... cap and rotor, wires, plugs, coil, fuel pump assy, coil pickup sensor, crank position sensor and have new ECM on the way, Cranks but won't fire. ... 1990 Dodge Dakota.
Jan 22, 2009 - have a 1993 dodge dakota sport that wont start. when you turn the key on there is no power to the fuel pump and does not fire. any ideas ... I just bought a1990 Dodge Dakota Sport 4x4 5-Speed, there is only one problem, it only .... I went to move it the other day, it would turn over, but had no spark or gas.
this sounds like a bad speed sensor which communicates with the ECM and TCM to shift the transmission which will cause the speedometer and the transmission to act the way it is.
Your transmission is the 42RE, formerly A500SE, and A904 way before that. Due to the electronics involved, you would need the computer and associated harness for a manual Dakota if you were thinking about using a non-electronic automatic.
IAC ( idle air control ) location. You need to be sure to clean pintle (pointed end) of motor as well as spray clean inside port where it comes out of. Careful not to lose small "o" ring on motor.
dose the trans act up at the same time the speedo cuts out if soo you definatly have either an intermittent speed sensor problem of wiring in the speed sensor circuit. speen sensor is located on the extension housing of the transmission (2wd) ot back of transfer case (4x4)
Overdrive is electrically controlled by the pcm. When it's cold you need to check to see if the pcm is grounding the overdrive solenoid. If it is the solenoid might be bad or if the pcm is not grounding it then you need to check items that would cause the pcm to lock out overdrive. Coolant temp, TPS, Vehicle speed sensor, ECT. You will have to have it scanned to do this.
Do you have spark? Do you have fuel? Which are you missing? TIP.A quick check for spark.........give it a spray of starting fluid....if it runs....you've got spark. No spark usually means......a bad coil or ignition module on the 3.9. No fuel is usually caused by a bad fuel pump.
The transmission/computer is designed not to go into overdrive until it reaches a certain temp and I don't remember what the temp is. Mine does same thing and it has 250,000 miles on it. When you start your truck up do you start it and warm up in neutral? The transmission fluid won't flow unless it is. There is know way to force it to shift into overdrive until it warms to the set temp.
×