2003 Chevrolet Avalanche Logo

Related Topics:

A
Anonymous Posted on Sep 18, 2014

How do you remove brakelight cover

The snugtop camper top is on 2003 chevrolet avalanche.

5 Related Answers

countrysi248

Jerry Koski

  • 443 Answers
  • Posted on Apr 24, 2009

SOURCE: I need to remove the door panel on my 2004 Avalanche

There are plastic clips that hold the door panel inplace .. First look for any hidden screws near the door handle . there might be a little plastic cover that you need to remove with a small screw driver to find the screws.. look under the handle also to see if there are any hidden screws . next take a flat blade screw driver and start at the bottom corner and try gently prying the door panel off . try to stay close to the plastic clips not to damage them by prying real hard .. once you have snapped them loose all the way around .. lift up on the door panel to remove it from around the window lip and out it should come.. holler if you have any problems.. usually The mirrors on the chevys are up above the panel and there is a triangle plastic cover over it on the inside .. it will pry off also gently and there are 3 nuts there that need to be removed .. use caution these fall behind the door panel ... holler if you need more. Jerry

Ad
emissionwiz

Marvin

  • 85242 Answers
  • Posted on Jul 21, 2009

SOURCE: 2002 chevrolet avalanche oil filter location

bottom rear of the engine at the transmission bell housing.

Anonymous

  • 1796 Answers
  • Posted on Sep 03, 2010

SOURCE: where is the throttle body located on a 2003

Hi!!

The Throttle Body is the part where the Air Filter Hose Connects into. The Throttle Position Sensor and the Idle Air Control selenoid are located.

Don't forget to rate this post!!

Anonymous

  • 8 Answers
  • Posted on Dec 22, 2010

SOURCE: need to replace a tailgate handle on a 2003

I had the same problem. I used a flat screwdriver to pry the fiberglass piece out which created just enough room to wiggle the latch mechanism out the top. Getting the new latch in was a little more difficult, but 5 minutes of prying and wiggling and I got that in the same way it came out.

Jonah Oneal

  • 14092 Answers
  • Posted on Aug 17, 2011

SOURCE: front end shakes when hitting

FRONT END SHAKES WHEN YOU HIT POT HOLES SOUND LIKE BAD SHOCKS.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

How do I disable a seatbelt chime on 2003 Chevrolet avalanche

Easiest way is to locate the chime and remove or snip one of the wires going to it. Voila - no more sound!

Use electric tape to cover the wire you removed.
0helpful
2answers

How do I change the oil pressure sensor on 2007 Avalance

On both the V6 and V8 engines the Oil Sensor is located on top of the engine at the rear. You will need to remove the top of the intake manifold to get to it.
0helpful
1answer

Where are the airbag sensor on a 2003 avalanche

in the center of the console box, front side of the transmission top cover assembly you will find it
0helpful
1answer

Were does the knock sensor goes in a Chevrolet avalanche 2003

knock sensors there are two are underneath intake manifold. make sure whoever replaces them they must use RTV SEALANT ON BOOT COVERS SO THEY DONT FAIL AGAIN! any questions feel free to contact me at joedatech.com
0helpful
1answer

Need to replace a tailgate handle on a 2003

I had the same problem. I used a flat screwdriver to pry the fiberglass piece out which created just enough room to wiggle the latch mechanism out the top. Getting the new latch in was a little more difficult, but 5 minutes of prying and wiggling and I got that in the same way it came out.
2helpful
2answers

Where is oil sending unit on 2003 Chevy Avalanche

Not sure what engine you have, most 4.8, 5.3, 6.0s are WAAAY back in the middle of the engine facing the drivers side, very difficult to get to.
0helpful
1answer

Changing a headlight on 2003 avalanche

no.you should see a pin on top of headlight remove this pin and light will come out and you can change bulb. it may have two pins not sure they changed around that year you will turn pin out of its holder and then slide it out if it is two they will be vertical if it is one it is horizontal
Not finding what you are looking for?

36 views

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...