HOW DO I RESET SENSORS AFTER WATER HAS ENTERED ENGINE OIL AND NOW CAR WONT CRANK OVER
Won\'y crank or won\'t start? Deal with crank first.
If it won\'t crank chances are there is water in a cylinderand the starter can\'t push past that. Yhe water in the oil came from somewhere. The engines cooling system? If you have water in a cylinder, you more than likely have a bad head gasket or cracked head. Find that cylinder! Pull all the sparkplugs. Now with no one in direct line with any spark plug hole and observing which hole ejects water, Tap the starter. The ctlinder taking water will spit it out,forcefully, so watch but don\'t stand in the way. This will show you what hole is taking water. The water seeps past the rings through the ring gaps and ends up in the oil in the pan..If water in cylinder proves present, the head will need to be remove. When you do so, verify your suspicions by examining the head gasket and surface of the head. The head should go to a machine shop for their inspection of condion and valve condition..Lots of miles, have a valve job done. It\'s all yours my friend, The won\'t start problem is obvious. Won\'t run on Water. If you dismantle this enginetop end, have all you specs and relative info in hand before diassembly. Timing Chain/belt
installstion and timing mark info. Head bolt torque specifications, Valve adjustment specs Take a picture, maybe more than one, of the top of the engine with the air cleaner and without air cleaner. Take several picture at different angles focusing hard on the routing of the hoses and vacuum lines. Take pictures of anything you feel you may need on reassembly.You can delete pictures, but you can\'t recall what miss your notice.. Hey! Keep in touch and feel free to ask if you need further assistance. We have plenty of the bestyou can turn to for help. Thank you and Good Luck _Ned_
SOURCE: HELP
near the throttle body part there is a electronic idle control valve either this control valve is defect or there is a leak between the body and the valve.
regards Sam (holland Europe)
SOURCE: 2002 Dodge Intepid engine change now it wont start
how long ago did dealer do the job, if recently I think they should feel some obligation to assist you.
SOURCE: Car won't start
on a 3.5 look on passenger side just below the air duct.I pulled mine from the bottom of my car.it looks similar to the cam sensor located at driverside on top of the timing belt cover.
SOURCE: car won't start but will crank and turn engine
first check the spark plugs wire, and distributor cap and rotor.
SOURCE: 1992 dodge 318 engine turns over, but no start. No
if truck has a ceramic ballist resistor near and connected to coil this could be problem or the crk posistion sensor could be too, i would change ballast first if you have on your truck appx cost $10
854 views
Usually answered in minutes!
×