How does a 2001 cavalier Chevy rear light license

SOURCE: How do you change the headlight for a 2001 chevy cavalier

i actually just did this a couple days ago, this takes about 20 minutes and a little bit of patience. When you pop your hood you will see a protective piece of plastic over the headlights/radiator, you firstly have to remove the plastic clips holding that piece then pull that piece of plastic off, once done u will see 2 bolts holding each headlight in place, i believe it is a 9/16 socket but if not just find the one that fits, remove the 4 bolts (2 for each headlight) and pull the headlight in an up and outwards manor. if you feel any resistance do not yank look at why it is catching and clear it, then it should just pop out (the headlight and the corner piece and clipped together so dont pull it too far out) then when the bulb is accessible pull the old bulb, put the new bulb in and voila place the headlight back into position, redo the 4 bolts holding the headlights and re-attach the plastic headlight/radiator cover. Enjoy the new lights

SOURCE: 2001 chevy cavalier turn signal relay location

Above the brake pedal

SOURCE: The rear window defroster in my 2001 chevy

check the connectio non the rear window usually located on the left or right side of the rear window

SOURCE: replace fuel pump on a 2001 chevy cavalier

First, if your car still runs, pull the fuel pump relay, and start your car, letting it run until it dies. This will depressurize the fuel system. Then you must support the fuel tank, and take loose the straps that hold it up. Slowly lower the tank until you can unhook the tank filler hose and overflow hose by taking the clamps off and sliding the hoses off. lower it some more, and unhook the fuel lines; they require you to insert a special tool around the edge of the connection, however this can be improvised with screwdrivers or a piece of plastic or metal bent into a C shape. Next unhook the wire connection. Once you get it down, it's easiest to empty as much fuel as you can; as this will help you get it back into place. The fuel pump is inside the tank, which locks into place with a 1/8th turn. You will need a hammer and a brass punch for this job, as it needs to be tapped around to unlock. It will then lift out. Compare the two pump assemblies. The inside parts can be slightly different, but ensure that the fuel lines are IDENTICAL and the wire connection is IDENTICAL. The new one will come with a new silicone seal. Ensure that you don't put the new one in in such a way as the float doesn't bind, otherwise you'll be doing this procedure again if you don't like guessing how much gas you have. This can be a challenge to wrestle with putting the new one in, as you have to push it down to compress the new seal, and turn it to lock it. Once you get it started, you can let up and use the hammer and punch again to tighten it the rest of the way. Next, put it back together just as you took it apart, and don't forget to hook up the wires, hoses, and fuel lines. No tools required for the fuel lines, they just snap together. Once everything's tight and hooked up, put gas back in it, and if you haven't already, put the fuel pump relay back in. This you can do as soon as the car dies, and is completely optional if the car won't run at all. You are now ready to start it up, but turn the ignition on to the run position, wait a few seconds for the pump to pressurize, and then start it. Have fun, and feel free to ask any questions should you have any.