If you put new piston rings in the engine without doing anything to the cylinders themselves, you most likely have a sealing problem between the rings and the cylinder walls. This will cause blowby and pressurize the crankcase causing the problem. Also check for a clogged PCV valve.
Testimonial: "Thanks , I think you are right."
Will hone bores are they seem glazed and also check PCV valve.
Terri, you were correct - thanks Mike
No problem. Glad you got it working again.
After all the issue was the cylinder wall or the pcv valve?
×
SOURCE: over heating mitsubishi k4n engine
use 50-50 antifreeze and change your radiator cap but first drain all the old antifreeze out.. hope this help
SOURCE: 1998 leganza motor smokes when it warms up
If the smoke is white, or steam it is water. you might have cracked the head or warped it. Did you get it looked at before you put the new gasket on? If the smoke is black then it is oil. Do a compression check and see if you don't have a bad cylinder. They should all be about the same give or take 5 lbs.
SOURCE: pajero diesel 2800 radiator coolant overflows, engine temp. up
REMOVE RAD CAP AND RUN ENGINE AT 3000RPM WITH ALL HEATERS ON SOUNDS LIKE AIR LOCK, ALSO CHECK IF HOSES ARE HOT
1,381 views
Usually answered in minutes!
×