Question about 2005 Ford Escape XLT

3 Answers

WHERE IS THE LOCATION OF GEAR POSITION SENSOR?

NO MATTER WHAT GEAR IT IS IN - IT READS "DRIVE"

Posted by Anonymous on

Ad

3 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 1,882 Answers

Tommy's got you covered here

Posted on Nov 24, 2019

Ad

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I've found a video that will be very helpful. Kudos to whomever made the video.
https://www.bing.com/videos/search?q=gear+position+sensor+2005+ford+escape&&view=detail&mid=8A01FEFADCC9FD63A6188A01FEFADCC9FD63A618&&FORM=VRDGAR

Posted on Nov 23, 2019

Ad

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 457 Answers

On top of trans but you need special tool to set in right place.

Posted on Aug 17, 2014

2 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Rob W

  • 70 Answers

SOURCE: 2000 ford explorer 5r55E stuck in second gear and all gear positions

It sounds like the linkages have let go. If this is the case, then drive it to a repairer straight away. If you turn the vehicle off you might not get it started again.

Posted on Oct 10, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Code P1121 for TP sensor - where is it located on engine of 2002 4.0 ford ranger


P1121 - Throttle Position (TP) Sensor Inconsistent with MAF Sensor The PCM monitors a vehicle operation rationality check by comparing sensed throttle position to mass air flow readings. If during key ON engine running self-test the comparison of the TP sensor and MAF sensor readings are not consistent with calibrated load values, the test fails and a diagnostic trouble code is stored in continuous memory.
  • Air leak between MAF sensor and throttle body
  • TP sensor not seated properly
  • Damaged TP sensor
  • Damaged MAF sensor
Drive vehicle and exercise throttle and TP sensor in all gears. A TP PID (TP V PID) less than 4.82 % (0.24 volt) with a LOAD PID greater than 55% or a TP V PID greater than 49.05% (2.44 volts) with a LOAD PID less than 30% indicates a hard fault.
Do you know what scan data on a scan tool is ?
How to Install Replace Throttle Position Sensor TPS 2001 Ford Ranger Buy...

Jun 21, 2017 | Ford Cars & Trucks

1 Answer

Where is the crankshaft sensor position located on a 2004 V8 Nissan Armada


The crankshaft position sensor is located on the transaxle housing, facing the gear teeth of the drive plate.

Jan 18, 2017 | 2004 Nissan Armada

1 Answer

Location of trans speed sensor 3 pin location 2004 solar v6 automatic p0500 speed sensor trouble code


no what matters is if the pulses are good.
and the transmission not slipping.
the TCM is not genious level yet.

are you asking what P0500 means.
or want us to tell you all things stated in fSM for this code.
what? guessing you can do .
ever heard of alldata.com (DIY)
ever read that page on 500s?
i guess not.
3.3L v6 ?
quote:
Trouble Code Conditions: P0500
VEHICLE SPEED SENSOR "A"
The ECM detects following conditions simultaneously for 2 secnonds (1 trip detection logic):
No SPD (speed sensor) signal while ECM detects NC (trans­mission counter gear) signal is more than 300 RPM Park/Neutral position switch is OFF (When shift lever is in other than P and N positions) Possible Causes:
  • Open or short in speed sensor circuit
  • Speed sensor
  • Combination meter
  • ECM
  • Skid control ECU
im trying to decode that too, the sensors
are called, C3 counter gear sensor, and Turbin T3 sensor
but the book keeps changing names in the book.

i think it means, counter gear shows correct RPM
but the turbine gear sensor T3 is dead.
while in gear. is too hard for them to say. so i said it.
and my guess, moving,
after all transmission slip moving
in fact i can scan your car and prove that
i scan it in park, then indrive, no moving
got 500s, or are 500 happening flogging engine.

but the ECU signal is either dead for turbine sensor or is way too slow. see incongruity from 300+ rpm on counter gear.

500 means dead, not intermittant.
i looked at all codes for turbine.

so my best guess (no real fsm only alldata)
is Turbine is the clutch sensor. (input rpm to trans-clutch)
and counter gear is tail shaft sensor.? (output speed)
so the front clutch sensor is dead
or being grounded out, or is not connected, (rusty conns?)

Most FSM made do a poor job, at showing possible bad parts.

here is better
  1. the sensor is weak or dead
  2. the sensor connections are bad.
  3. the sensor, signals do not arrive at the PCM /TCM, due to bad wires, or anything on that line shorting that line out.
  4. better (yes?, this is electronics) no a parts swap game.

if the car drives ok then the trans does not slip.
the TCM sees both ends and can detect, bad sensors or gross slip.
i think it means bad sensor. in this case only.

what does this mean?
  1. having difficulty locating it
can buy one, find one, can't insert it, or?

Feb 13, 2015 | 2004 Toyota Solara

1 Answer

Location of transmission throttle valve position sensor for 1997 voyager 3.3


Check the transmission control module . You can find a Youtube video on where it is and how to remove it.

Jul 28, 2017 | 1997 Plymouth Voyager

1 Answer

2000 ford explorer 5r55E stuck in second gear and all gear positions


It sounds like the linkages have let go. If this is the case, then drive it to a repairer straight away. If you turn the vehicle off you might not get it started again.

Oct 10, 2012 | 2000 Ford Explorer

2 Answers

P0345 Code, where is camshaft position sensor "A" (bank 2)


The Camshaft Position Sensor (CMP) on the 4.0L 6cylinder engine is bolted to the top of the oil pump drive shaft assembly. The sensor and drive shaft assembly is located on the right side of the engine near the oil filter.

a4b74c1.jpg

Fig. 1: Component locations-ES300

a7bce64.jpg

Fig. 2: Component locations-ES300



Hope this help; remember comment and rated this. TY for using Fixya.



May 06, 2010 | 2002 Lexus ES 300

1 Answer

Speedometer not working all gauges work 700r4 trans ohms r good have ac voltage at cluster changed cluster when in air in od doing about 60mph speedo says 10mph


Is the speed sensor that you are using the original one, or is it from the Camaro, or is it new for an 89 K1500?

The worm gear inside of the transmission on the output shaft that drives the speed sensor gear is not damaged?

No matter what speed sensor is installed the speedometer still reads the same?

May 02, 2010 | 1989 Chevrolet K1500

1 Answer

No oil pressure, camshaft position sensor error,


Yes, the sensor is in small housing the goes in the hole where the distributor used to go. That also drives the oil pump so don't drive it you'll ruin the engine. It's located down under the throttle body, near transmission end of the engine.

Jan 04, 2010 | 1997 Mercury Sable

1 Answer

Auto transmission problem


I had a similiar problem. The D4 indicator light stays on. I changed the transmission computer and it solved my problem. The computer is located in the floor underneath the dash on the passenger side.

Jul 06, 2008 | 1991 Honda Accord

Not finding what you are looking for?
2005 Ford Escape XLT Logo

Related Topics:

53 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

85219 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

gerry bissi

Level 3 Expert

4388 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...