SOURCE: starter for dodge caravan 2000
DISCONNECT THE BATTERY, JACK UP AND SUPPORT YOUR CARAVAN. LYING ON YOUR BACK LOCATE THE STARTER WHICH IS ATTACHED TO THE ENGINE THROUGH THE BELL HOUSING .THERE ARE TWO 15 MILIMETER BOLTS THAT HOLDS THE STARTER ON . AFTER BREAKING THE BOLTS A 15MM WRENCH WOULD BE USEFUL.
SOURCE: Where can I get access
door locks will not work manualy or remotely. back lid works with remote and all lights turn on and off when using remote.
SOURCE: Need install instruction for starter on 2002 Dodge Caravan
This is alittle tricky getting to some of the bolts but its not too hard to do otherwise. 2 bolts hold on the starter IIRC they are 13mm bolts. make sure your battery is dissconected by the black cable. then there will be 2 nuts holding on the starter wires. one will be 8mm and the other 13mm. remove them with care cause the wires may and can break. when you remove starter check wires for corrosion or if they look fraigle. repair them if damaged.
then to put it back in is the same way you took it out. should take about 1.5 hrs total if you have never done it before.
Overall i would say skill level 3/10 only cause its trickey getting to that top bolt sometimes.
good luck,
Michael
SOURCE: 2006 dodge caravan, 6 cyl.
Firts time swap spark plug & ignition coil between two different cylinders and read again if the same #2 cyl. misfires !
If #2 cyl. is OK and another cyl. misfires then spark plug or ignition coil is out of order and must be replaced.
If #2 cyl. misfires again then #2 injector must be checked !
If ignition coils & spark plugs (complete set for 6 cyl.) are replaced then you must check #2 injector !
SOURCE: 2006 Grand Caravan: Can't get pcv valve from a 3.8 dodge grand caravan...
I just replaced mine and had the same problem. If you look at the new one, you should find a small hole at the base of the metal tube. Using a mirror, I located the same hole in the one in the valve cover and inserted a pointed awl into it and was able to pry it out. Do it slowly since you are prying against plastic. When inserting the new one, I found that it should not be inserted as far the original one was and has a gentle snap.
233 views
Usually answered in minutes!
Hi Anonymous, I want to help you with your question, but I need more information from you. Can you please add details in the comment box?
×