HOW TO LOCATE AND PULL DOWN GLOVE BOX TO LOCATE FUSE BOX

fuse panel on the inside of the car drivers side

Ac/clutch relay should b under hood
I'm assuming u mean blower motor resister behind glove box area..fan speed has no relay/fuse..just control unit/blend doors/blower motor basically

m

• You have to open the glove box and turn the two finger switches 1/4 turn.
  If the blower isn't working its probably not the fuse anyway. The part you need to replace is the fan speed resistor.

Hello! Coil of Heater Relay is supplied through Fuse "IG1 2" (10A)...Located in the Drivers Side Box...Contacts of Relay are supplied through "Heater Fuse (50A)...Located in Engine Relay Box...Blower Motor has a 2 wire connector with wire colors: Black/Yellow (Pin 2)...And White/Blue (Pin 1)...Pin 1=Ground and Pin 2=Battery when Relay pulls and contacts close...
The Blower Resistor Pack (Which fails often) controls the fan speed...BUT, there is a fuse inside the assembly...If it blows = No Fan...Located on the top of the heater/AC box and can be accessed through the Glove Compartment...Guru...Saailer

I’m happy to help further over the phone at https://www.6ya.com/expert/david_6df67de3b14de867

Here's a great video too that will show you where it's located and how to replace it.">

Fan motor or fuse . Rap on fan motor while unit is on

C-19 Blower motor fuse 25A located in cabin fuse box. Left hand footwell on LHD vehicles, right hand dashboard on RHD vehicles.
Start by checking blower relay B-36 in the engine compartment fuse and relay box. Remove the relay. Jumper directly from battery to pins 85 and 86. (also see here: http://www.fixya.com/cars/r5544622-wire_relay if you dont know about relays) The relay should click Now measure across pins 30 and 87. Measurement should be 0 ohm.
Remove the blower motor(3 screws on the bottom of the unit under the passenger side dash) and connect jumper leads from the battery directly to the blower motor to see that it operates.
The blower motor resister is mounted on the ducting between the motor housing and the heating unit. Remove to test
Measure :

• pin 1-2 : 2.4 ohm
• pin 2-4 : 0.9 ohm
• pin 2-6 : 0.28 ohm
• pin 2-3 : 0 ohm

My 2002 I35 has the blower fuse under the hood in the fuse box in the engine compartment. The fuse box cover has the "key" or description of which fuse is which. If the blower fuse is bad and you replace it, only to have the fuse burn again then I would check the blower resistors that are located behind the glove box. Very common for one of these resistors to go bad causing only low speed operation of fan. Burns the fuse when you try to operate the fan on the higher speeds. Good Luck

The BLOWER MODULE is located on the A/C EVAPORATOR housing located UNDER THE HOOD passenger side firewall. Has 2 electrical connectors. Mounted with 4 screw bolts.Hope this helps

Test the blower motor by jumping 12 volts to the blower motor connector, if it works you have a defective blower motor speed control resistor which is located just next to the blower motor, i recommend u replace both as the blower motor ages it draws more current and this causes the resistor fail, u should be able to buy these parts in the aftermarket, the dealer parts will be very expensive.

The blower motor is behind the glove box. Remove the glove box (3screws, 1 on the left side and 2on the bottom). Remove the glove box lower frame (4 screws). The blower motor assembly will be on the right hand side under the dash