SOURCE: 2000 Chevy Silverado need to reset oil change code.
Turn the ignition key to the run position and pump the accelerator 3 times within 5 seconds.
Please leave feedback!
SOURCE: 2005 Chevrolet Silverado 2500HD 4x4 Oil Change Reset
Not positive 05 is the same but on my 02 you turn the key to the on position and pump the gas pedal 4 times.
SOURCE: how to reset the change oil light on a 2003 chevy
Information courtesy of synthetic-direct.ca
Chevrolet Suburban/GMC Yukon XL, 2000-05 Chevrolet GMC Trucks Silverado, Sierra, 1999-05 Chevrolet Venture 2000
Turn the ignition key to the RUN position. Fully push and release the accelerator pedal 3 times within 5 seconds. If the CHANGE OIL SOON light flashes 2 times, the system is reset. However if the light comes on and stays on for 5 seconds, the system did not reset. Repeat the procedure if the system does not reset.
Best of luck.
Greg
SOURCE: process to change fuel pump on 2001 chevy silverado 1500
take the six bed bolt loose and then take three buddies slide the bed back put in the new pump slide it back n place and put the bed bolts back in. if u drop the tank u can easily break the hard plastis lines that go to the fuel tank. u only have to take the fill lines and taillight wires loose this way its alot quicker, and easier.
SOURCE: how do I replace the transmission coolant lines
Take a small 90 degree pick. Inspect the fitting closely. Use the pick to "roll" the retaining clip off the fitting. The line will simply pull once this is done. U can install the clip first on reinstallation (inspect them closely) and then simply push the line into the fitting. It will "click" into place. Note u will have to orient the line perfectly to push in.
579 views
Usually answered in minutes!
×