Brake pedal went to floor, replaced master and bleed all wheels, still goes to floor with engine running. Will pump up with engine not running.
SOURCE: 94 S-10 Chev Brake problem
This is an easy fix un plug the abs sensor from spindle abs light will come on but the brakes will work only abs will not
SOURCE: brake pedal goes to floor
there is still air in your hydraulic lines somewhere bleed the system with a pressurised power bleeder and you will get instant results
SOURCE: brake pedal dropping to floor
do u have the antilock brake bleeding tool? if not you will need to have the dealer bleed the brakes, the ABS control valve must be electricaly held open to bleed the brakes there of course is a special tool for this.
Testimonial: "Thank You"
SOURCE: how to bleed the brakes on a1999 chevrolet venture
Start with brake in the rear that is the farthest away from the master cylinder ( if your master cylinder is on drivers side start with passenger rear,pump up brake pedal until hard have someone else open bleeder valve until air or fluid squirts out,while holding brake pressure even if goes to the floor dont release pedal until bleeder valve is tightened or you will **** air back into the line,do this several times making sure you get a full stream of brake fluid and no air,continue to other rear wheel and then proceed to front wheel furthest from master cylinderand then final wheel. if you still don't have brakes change master cylinder and bleed all brakes again.
455 views
Usually answered in minutes!
×