SOURCE: removing door panel to access window motor on a
You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door
SOURCE: rear door panel removal
You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door
SOURCE: 2002 Sayurn vue 3.0L
Under the intake manifold, it will need to be removed. Not too hard to do for the average diy but recommend buying a repair manual as a guide. you will need a 1/4" drive T30 torx socket with a long extension one of the bolts is hidden but the others are under the black cover on the top of the intake. you will also need to remove the coil pack held on with torx bolts. 8 or 10 inverted torx socket needed for that.
SOURCE: door panel removal for 2002 9-5 on driver rear
On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls
490 views
Usually answered in minutes!
×