SOURCE: How do you remove the fan and clutch assembly from the water pump
Your post was really old before I read it but... You need a pair of special tools... one to remove one to install clutch with. If you don't do this often the price is not justified. Just get a decent compressor at a junkyard, put it in and have it charged!!! If youre talking about the fan & clutch on the front of the water pump, just unbolt it and put a new one on!!!
SOURCE: Removing doors from Jeep Wrangler - Dome Light Stays On
I have a 97, and my fuse for that is behind the glovebox. Open the box, slide the end of the strap to disconnect it, then remove the box. The fuse is marked. Something like "Dome lt. elim." I think it's located one up from the bottom right. This can actually be done without removing the glove box. For a more permanent fix, quadratec.com has a switch that plugs into the fuse location and mounts under the dash, so you can just flip the switch. Hope this helps.
SOURCE: 2000 jeep wrangler fuse keeps blowing?? What do I
That or the wiring to it is shorted at some point. Remove the connection at the center back of the socket and replace the fuse--if ok, replace or repair the socket. If still blows fuse, check the wire you removed for damage near any metal object.
SOURCE: remove 2007 jeep compass bumper cover
Hello, I can assist you. Begin by rounding up the necessary tools:
7mm socket and ratchet
7mm wrench
10mm socket
screw driver or panel removal tool (for push rivets)
Now go to the following site and take a look at the step by step instructions and pictures which does a nice job of explaining this entire job. Thanks for using Fixya!
http://www.jeeppatriot.com/forum/showthread.php?t=6291
SOURCE: 2006 jeep grand cherokee bumper removal
check your metal bumper retainers attached to the front chassis there must be a hidden bolts and nuts thats still on that you havent seen yet remove it and take off the bumper bar( steel bumper)
Testimonial: "Thanks for the response.."
141 views
Usually answered in minutes!
×