CHECK ENGINE LIGHT 1993 FORD RANGER HAS A 1998 MOTOR
SOURCE: 1995 Ford Ranger ( engine light ) and stuff need help plz
if your obd2 scanner fits the connection you have obd2, obd1 connector is way differnt.
your code p1443
Control System
Canister Purge
Valve (Mechanical)
Malfunction
Monitors the fuel vapor
flow between the
engine intake manifold
and the EVAP
canister. The system
failure occurs when a
leak or blockage
between the intake
manifold, the EVAP
canister purge valve
and the EVAP canister
is detected by the
PCM.
l Pinched, blocked or
plugged fuel vapor
tubes/hoses (except
between fuel tank and
EVAP canister)
l Damaged EVAP
canister
l Disconnected, cracked
or cut fuel vapor
tubes/hoses (except
between fuel tank and
EVAP canister)
l Damaged EVAP
canister purge valve
Check for audible vacuum
noise in the engine
compartment or significant
fuel odor in the engine
compartment or near the
EVAP canister.
This link has all the codes you need.
http://rockledge.home.comcast.net/~rockledge/RangerPictureGallery/DTCs.pdf
SOURCE: 1998 Ford Ranger XLT turn signals, hazzard flasher not working
wire plugin on back of turnsignal switch not making a connecting
SOURCE: Check engine light is on. EVAP small leak
You need to check the purge and vent solenoids for proper operation. You need to check the pressure sensor for out of range ( defective ). You need to check the filler neck for cracks and make sure the clamps are tight. You need to check the vapor lines for loose fit. I've seen at the charcoal cannister where the lines connect it may not be on strait. A smok test will reveal this if its not sealing. You may have a leaking rollover valve or fuel pump seal on top of the tank. You may just have a vacuum leak under the hood, These trucks have an Evap management valve also that can be leaking or out of specs. Look on the emmisions lable or vacuum chart under the hood. This will show you the underhood components.
SOURCE: 1998 ford ranger idles rough, high then low
does car have engine codes? sounds like your idle air controle valve is sticking. or possible egr problem
SOURCE: eec or ecu (Engine Computer) location on a 1993
This has a brain box located on left fenderwell, Its a small aluminum box about 6x6
Testimonial: "That was quik and awsome I checked and BOOM there it was Thanks!!"
37 views
Usually answered in minutes!
×