SOURCE: mazda b2200 compression specs
those are average numbers and they are a little on the low but that is typical considering the age of the vehicle the compression should be 115 -120 psi.. hope this helps please rate this...thanks
SOURCE: 1991 mazda b2200- timing belt changed
The keyway and or the dot on the crank should be line at 12 oclock. You will see a point on the oil pump housing to go by. On the camshaft the pointer will be at 12 oclock also. Use the O on the camshaft to the top at mark. Be sure to look at the dist. roter to make sure that it is pointing at the #1 spark plug wire. I could get 180 out of time. If you do it right it should start up right away. then you can use a timing light to finish it.
Good Luck [email protected]
SOURCE: setting the timing on 1988 mazda B2200
All I can find at this time is 6 degrees BTDC @ 825 RPM in neutral, with park brake on obvioulsy.
SOURCE: price on a 1991 B2200 Mazda Pickup truck carburetor
Depends if you want new or used, Location, and a few other variables
SOURCE: 1989 mazda b2200 can not set timing
i have a 1988 mazda b2200 and i was sittin still runnin and it was a lil low in water and i was just ab to take off when it cut off. it made steam *** out the hood. the thing is its gettin eletric to the plugs and its gettin gas and i even tried a lil eather and its turnin over it just want crank. do u have a idea wat it could b? im thinkin it jump timeing.
885 views
Usually answered in minutes!
×