Have a Land Cruiser 90 Colorado 3.0ltr TD Auto that has no forward or reverse motion, engine revs up but wont drive, Synthetic oil smell when warm, transmission oil level fine?
SOURCE: quantity of engine oil used in 1 HD engine toyota land cruiser
if you have just bought the car change the oil and the filters asap on the grounds that the oil and filters may have not been changed for quite a while also change air and fuel filters also and grease any steering and tail shaft joints check brake fluid and water levels also and for any leaks around brakes gearbox and differential then every 5000km change oil and every 10000 change filters and spark plugs start with 4liters of oil let settle check level and keep topping up until close to full mark fill oil slightly under than over too much oil will build up pressure and burst oil seals in motor the more expensive the oil the better the quality its a bit like scotch whiskey best of luck glenn.......
SOURCE: 2004 Toyota Land cruiser key programming
you need to take it to the dealer so they can program the key to the car which requires there software. hope this helps
SOURCE: i need to remove the power steering rack on my
1. Lift the front of the vehicle, support on axle stands and remove wheels..
2. Loosen tie rod ends from hubs andremove them from rack ends.
3. Remove presure pipe from steering pump, and return pipe on reservoir, drain oil in suitable container.
4. Remove bolt on steering shaft universal and remove from rack by slightly tapping with suitable drift .
5. Remove 4 bolts securing rack to chassis.
6. Remove brackets securing pipes on rack *** well as chassis, slide rack to opisite side of sreering
shaft, remove pipes from rack.
7. Remove rack
SOURCE: Toyota land-cruiser
If the "overdrive off" light is flashing, this indicates an error condition in the transmission ECU.
There is a diagnostics procedure you can follow, but it is a bit too long to go in to here. Try and track down a copy of the Toyota service manual, number RM315E (searching the ih8mud forums is a good start) and follow the procedure in there for reading the fault codes.
It involves bridging the diagnostics connector in the engine bay (facing the front of the vehicle with the bonnet open it is to the right of the engine on the bulkhead) - easy to do...
SOURCE: Toyota Land Cruiser Prado (LC90) Owner's Manual (free download)
i need onwer's manual of toyota prado 2005 3.4L
97 views
Usually answered in minutes!
×