SOURCE: crankshaft position sensor
Here you go:
Fig. 3: Crankshaft position sensor (1) is located next to the oil filter (2) on the 2.4L engine
SOURCE: crankshaft sensor location on 2001 oldsmobile
. Its above the starter going into the side of the block. (front side of the engine) Disconnect the battery. Remove the starter. Remove the wIre CONNECTOR plug to the sensor. The sensor has 1 bolt holding it in. Remove the bolt, you may have to wiggle the sensor at the base a bit as you pull it out. Replace, and make sure it is pushed in all of the way. Replace the bolt, wire plug, starter, reconnect the battery.
SOURCE: i need to know where is the oxygen sensor locatted
follow the exhaust pipe from the manifold on the engine and you will find it before you reach the middle of the car.
SOURCE: Where is the Crank Shaft Position Sensor located
The crankshaft position sensor is located just above the starter on the engine block.Hope this helps.Good luck.
SOURCE: where is the crank position sensor circuit located
The sensor is on the front side of the engine behind the starter (3.5L).
324 views
Usually answered in minutes!
×