SOURCE: 2007 ford e350 van, reverse lights wont work
On the side of your transmission will be a switch with several wires coming out of it. This is your reverse switch that turns on your reverse lights and most likely needs to be replaced
SOURCE: turn signals not working
you can try the solution i suggested here
http://www.fixya.com/cars/t3624308-turn_signals_dont_work_but_emergency
The flasher on that model is hard to find so it could be the problem
SOURCE: 2001 F-150 cruise control stopped working.
really tough to do on the net but first we need to know about any codes...
Hold speed control OFF button, and turn ignition switch to RUN position. CRUISE indicator should flash once to indicate successful entry into self-diagnostic mode. If CRUISE indicator does not flash, start procedure over. If CRUISE indicator still does not flash, repair system by symptom there might be some switch concern
If CRUISE CONTROL indicator flashes once followed by 5 additional flashes, replace speed control servo/actuator.
Release speed control OFF button. Within 5 seconds in entering self-diagnostics, press speed control ON button. Press remaining speed control buttons in the following sequence; ON, RES, COAST and SET/ACCEL.
As each button is pressed, CRUISE indicator will flash.
Wait until indicator light goes out, then press next button. After sequence has been completed, indicator light will flash to indicate test passed or failed. With the codes we can then better diagnose your concern
Immediately after static test has passed, actuator performs a dynamic test by automatically operating throttle .04-.40" (1-10 mm). Observe throttle movement to witness any sticking in cable or linkage. Ensure throttle returns properly. Turn ignition switch to LOCK position. If self-diagnostics do not pinpoint fault there is more we can do but tough over the net
SOURCE: Reverse light does not work,
If the bulb and the fuse are good, (the fuse will affect other circuits as well, not only the reverse lights), your next stop is the reverse light switch. It is located on the gearbox and is a switch with two wires coming from it. Remove the wires and touch them together and see if the reverse light comes on with the ignition on. If they do, you need to replace the switch.
Well the brake light and turn signal circuits are on two different fuses, but they both go thru the turn signal switch.
So I would start by checking for power in and out of the turn signal switch for each circuit.
105 views
Usually answered in minutes!
×