Car
SOURCE: 2005 Ford Mustang GT -loud clicking noise in audio system
There is a possibility that the cellular phone is interfering with the audio system. Cell phones communicate on their own with cell hubs to change locations, or to receive mails. Try to place the celular in a different position, or to turn it off on a single trip to see if the clicking disappears.
SOURCE: 2005 Mustang GT, service engine
There is an error that is active in the system. I would suggest to have a scanner connected to the car. Some shops would let you borrow their scanners. The error would help you accurately identify the problem.
SOURCE: engine code po456 on a 2005 mustang gt
It's a code related to an EVAP leak in your emissions system. A lot of people have reported loosening their gas cap, re-tightening it, and then clearing the code with success in it not coming back. Here is a bulletin posted on the issue from ALLDATA
http://ww2.justanswer.com/uploads/paynlessauto/2009-10-05_203445_fueltsb.pdf
Testimonial: "thank you clint or all others who resond to this site, some times us car owners need a break........."
The
following are the general instructions on the start of diagnosing any
electronically controlled engine or transmission problem. The
engine and the automatic transmission (transmission control is
only for automatics, engine is still computer controlled no matter
the transmission type) in this vehicle are computer controlled and in
most cases when a fault occurs a fault code is stored in the memory
of the computer control module. There are exception to this, such as
the Mass Airflow Meter and fuel pressure problems. What must be done
is to have all the basic testing done such as a scan of the system
for fault codes as well as a check with a live data scanner tool for
engine functions that are not within range of normal, a trained
technician is required to know what is correct and what isn't, then
based on careful diagnostics done from a factory repair manual the
correct part is replaced or the wiring repaired or the computer
replaced (known as the PCM or ECM,ECU), which is very rarely the
problem. Other basic checks must be done as well such as mechanical
problems with the engine as well as engine state of tune and mileage
on the engine. The transmission can have mechanical issues as well
such as no gear engagement at all or a failed pump or other pressure
related problems. Also engine mechanical problems can and do cause
many drive-ability related problem such as rough idle and other
symptoms.
Disconnect the battery for 24 hours. to reset your computer.
The
following are the general instructions on the start of diagnosing any
electronically controlled engine or transmission problem.
The engine and the automatic transmission (transmission control is only for automatics, engine is still computer controlled no matter the transmission type) in this vehicle are computer controlled and in most cases when a fault occurs a fault code is stored in the memory of the computer control module. There are exception to this, such as the Mass Airflow Meter and fuel pressure problems. What must be done is to have all the basic testing done such as a scan of the system for fault codes as well as a check with a live data scanner tool for engine functions that are not within range of normal, a trained technician is required to know what is correct and what isn't, then based on careful diagnostics done from a factory repair manual the correct part is replaced or the wiring repaired or the computer replaced (known as the PCM or ECM,ECU), which is very rarely the problem. Other basic checks must be done as well such as mechanical problems with the engine as well as engine state of tune and mileage on the engine. The transmission can have mechanical issues as well such as no gear engagement at all or a failed pump or other pressure related problems. Also engine mechanical problems can and do cause many drive-ability related problem such as rough idle and other symptoms.
340 views
Usually answered in minutes!
×