Installing radio with bluetooth and steering wheel interface, radio only comes on when key is turned and chimer is going off and door is open. When car is turned all the way on no sound comes out.
Make sure you have connected the remote amp wire. This should be blue/white on the radio and connected to the blue/white on the GMOS-4.
SOURCE: hello, my steering wheel is
All you need to do is turn your steering wheel to the left all the way till it stops then put your key in while still holding the steering wheel to the left, turn the key to the on position this should release your steering wheel!
SOURCE: thumping noise in chevy tracker 2000model
this noise sounds like your right cv axle. wou might want to have that checked out, they can do great damage if broken while
SOURCE: Radio will not shut off once key is removed...
radios have two feeds one from the ignition and one permanent live. if this is the case then you will find they have not fitted in correct order or even in some cases not at all on the ignition as it does not realy need it. you will also find if the stereo is brand new that all the cables will be clearly marked with a tag and you will have to disconnect the cable for the connection to the car warnign system.
SOURCE: key won't turn in the ignition
You may need to have they key reprogrammed at your local dealer. The keys have a transponder built in them as an anti theft device. If the transponder becomes damaged, it will need reprogramming or replacement. *NOTE* This costs MUCH more than just having your key copied (between $30 and $75 US)
SOURCE: 1992 Chevrolet Silverado radio wont turn on
check the connection to constant (usually yellow wire). Also check the remote wire (usually red) make sure they are both hooked up to where they need to be
?€¢
The digital radio receiver (DRR)
?€¢
The electronic brake control module (EBCM)
?€¢
The inflatable restraint sensing and diagnostic module (SDM)
?€¢
The powertrain control module (PCM)
?€¢
The radio
?€¢
The vehicle theft deterrent (VTD)
The class 2 serial data link also allows a scan tool to communicate with the above modules for diagnostic and testing purposes.
The class 2 serial data link on this vehicle is configured in a star pattern. There is no redundant path for the serial data to flow through. If a class 2 serial data circuit develops an open condition, the module connected by that circuit will not be able to communicate.
If not hooked up right the vehicle may not even start .
302 views
Usually answered in minutes!
×