SOURCE: How to replace headlights on 2000 Jeep Grand Cherokee
One long bolt at the top - requires a 7mm socket to remove the bolt. The light housing will pry out with a screw driver. There are three ball and socket type connectors that hold the housing in and I just pryed off the plastic housing carefully and "balls" pop out of the sockets. Finally, I was replacing the faded plastic housing and it came with a new wiring harness. It's impossible to reach the connector to use the new wiring harness that comes with the new plastic light housing. So just use the existing wiring harness with the new light assembly.
SOURCE: 2000 jeep grand cherokee 4.0 liter engine timing belt replacement
If you have the same pulley arrangement that most 4.0 engines have that pulley is an idler not a tensioner. Your power steering pump has a pivot bolt, and a slide under the pump. You adjust belt tension using the pump.
SOURCE: where is the low pressure side port of the ac on a
it will be the cooler temperature line going into compressor. With blue cap on service valve usually.
SOURCE: 95 grand cherokee oil pressure switch
Use a deep well socket and extension, it lives by the distributor.
SOURCE: Where is the oil pressure sending unit located on
Removal & Installation
Oil pressure sending unit
To install:
Trouble Code: P0846
A/T 2/4 Pressure Switch Circuit Malfunction
Possible Causes:
2/4 pressure is incorrect, or internal transmission faults exist
2/4 pressure switch circuit is open, shorted to ground or power
2/4 pressure switch is damaged or it has failed
TCM relay power circuit to L/R switch is open (loss of B+)
PCM/TCM has failed
373 views
Usually answered in minutes!
×