Several reasons could cause this:
1. Gauge faulty
2. sensor faulty
3. communication bus faulty
4. worn out engine
2014 long ago.
Agreed with the above answer. Start with the sensor as that is the most likely culprit.
you never said when, and how much.
oil pressure at idle can be 10psi and 3 times that at high rpm. (or bad oil, or fuel in the oil or some snake oil bs added)
5: pump is doing that?, it's pressure reg stuck open, and now runs wild. it will.
OP why not use a real PSI gauge there
a shop pressure gauge,?
it's accurate and does not lie to you
that is always first step
not guessing.
so you guess an the dash guage is not fibbing and you wreck a good engine.
no
we use a shop gauge first
then let TRUTH guild your next actions.
or lunch a good engine
so far, seems your on the good side of lucky... (nice no?) glass 1/2 full side.
why risk an engine.?
simple basic logic here.
respect the value of the engine.
×
SOURCE: serpintine belt
This link will take you to a picture of the diagram. If the link doesn't work contact me and I can email you the picture directly.
http://autorepair.about.com/library/illustrations/bl506a-lib.htm
SOURCE: LOCATION OF LIGHTER FUSE FOR 1996 JEEP GRAND
If you have the owner's manual look up fuses in the index, good illustration. If you don't, I do. It shows a relay and a 15 amp fuse. Look at the passenger kick panel, pull the cover, and it is #2 fuse (second from the top on the left) The see the relay you may have to pull the panel (two screws and a clip) the relay is the third cavity down, third row from the firewal side.
Let me know if this works for you?
SOURCE: The interior lights for my 1996 jeep grand Cherokee Laredo
Hello and welcome to FixYa
The interior lights wont turn off cant because it can't get a conncetion definitely a headlight switch issue common problem for that make
Part # 05137535AA Headlight Switch Probably a dealer item very simple to change this yourself. Hope this gets you going.Please Rate Me. And you can always Ask Me.
SOURCE: 95 grand cherokee oil pressure switch
Use a deep well socket and extension, it lives by the distributor.
SOURCE: i need to know where the oil pressure sensor is
It is located on the right passenger side of the engine near the oil filter housing. It threads into the engine block. It may also be located near the distributor on some 1996 models. Disconnect the single wire connected to the sensor, and use a socket to remove it. Wrap the threads of the new one with teflon tape, and install the new one hand tight and then tighten it 1/4 turn more with the socket. Reconnect the electrical connection.
172 views
Usually answered in minutes!
×