BRAKES; have all new brake pads, a.b.s. light still on, can i reset?
Dealer Item, you may be able to go to brake center also
Dont think so, you may have to replace the wheel bearings whick has an electric wiring harness that is probably bad, unfortunately you have to replace the entire bearing unit and not just the wire. usually it is the front wheel bearings you have to replace unless you have 4 wheel abs
SOURCE: Anti-lock brake light stays on
My wife took the car to exaust pro in Lexington, Ky. They did a scan and it was a speed sensor. They replaced it and it is fine. The car is great but after hearing all the complaints about the heater core we are going to sell it and get a Toyota Avalon. Also I replaced the antenna mast at 35k.
SOURCE: Brake warning light stays on
Hi and welcome to FixYa,
Initially, two possibilities:
Just a start, do postback how things turned up or should you need additional information. Good luck and Thank you for using FixYa.
SOURCE: 2000 chevy cavalier ABS and Brake lights staying on
You had it scanned? They didn't find any codes? If there were no codes, did the ABS computer even communicate? Also did you check the brake fluid, most newer cars have a float switch in the master. If the fluid is low that will set off the lights.
SOURCE: BMW 5 series - 2005 model - resetting service & waring lights
this needs to be done with a european capable scan tool,check around to see if someone has this tool, no other way sorry
307 views
Usually answered in minutes!
×