2006 Saturn Vue Logo

Related Topics:

A
Anonymous Posted on May 24, 2014

What does the crankshaft position sensor do in my 2003 saturn vue

1 Answer

automaniac

Level 2:

An expert who has achieved level 2 by getting 100 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Habit-Forming:

Visited the website for 3 consecutive days.

  • Expert 144 Answers
  • Posted on Jul 22, 2014
automaniac
Expert
Level 2:

An expert who has achieved level 2 by getting 100 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Habit-Forming:

Visited the website for 3 consecutive days.

Joined: Apr 06, 2010
Answers
144
Questions
0
Helped
66579
Points
288

It lets the computer know the position of the crankshaft and piston so that it can inject fuel at the proper time.

5 Related Answers

jmeyer847

Jeremiah Meyer

  • 204 Answers
  • Posted on Dec 06, 2008

SOURCE: check eng light with code po431 replased ox/sensors

P0431 is Warm Up Catalyst Efficiency Below Threshold (Bank 2). What is happening is this....the O2 sensor downstream of the Catalytic Converter is detecting the Converter is not working as efficiently as it should be (according to your cars specifications). 3 main causes of this is 1.) Defective O2 Sensor (which in your case elminates this one) 2.) Catalytic Converter is no longer functioning properly. or 3.) There is an exhaust leak. You will not notice any driveablitiy problems, however, you may get a rough/hard idle when its cold out. I would take your car to an exhaust shop and have them do a free exhaust system inspection. Alot of places like Midas/Mieneke Car Center/Monroe Muffler to name a few do these checks for free. Thanks for Using FixYa!

Sincerely,

JC

Ad
emissionwiz

Marvin

  • 85242 Answers
  • Posted on Feb 12, 2009

SOURCE: service engine soon light on 2003 Saturn Vue

Here is the definition of the code in GM manual:
P0128 - Coolant Thermostat Below Thermostat Regulating Temperature, this indicates the engine is running cold, u need a thermostat

Anonymous

  • 186 Answers
  • Posted on May 14, 2009

SOURCE: 2003 Saturn Vue WHERE IS THE TRANSMISSION FLUID REFILL

If it is a 2.2 Auto it has a VT25E Trans,A really bad experiment from G.M.There is no dipstick.The only way to check it per service is to remove the center part of the main drain plug while running in park,if fluid drains or trickles out they say it's full.You probally have other Issues inside the trans.Check your mileage they have a special coverage period for this Trans through Saturn Dealer!! They May cover it or do a partial coverage for you.Hope this helps

Anonymous

  • 543 Answers
  • Posted on Oct 04, 2009

SOURCE: 2003 Saturn VUE Steering Column Noise and Resistance

i am a saturn tech and ive never heard of this concern,the columns do go bad but they just set a ses light and cut out power,the column could be bad,it could also be the intermediate shaft u joint binding,,,i rec take to dealer, could be serious

Anonymous

  • 39 Answers
  • Posted on Mar 02, 2010

SOURCE: 2003 saturn vue trouble code p1599

P1599 IS A STALLING ISSUE COULD BE BAD GAS / BAD FUELPUMP DIRTY FUEL FILTER
DISCONNECT BATTERY AND SEE IF THE LIGHT COMES ON AGAIN
U2107 HAS SOMETHING TO DO WITH THE COMPUTER LOOSING POWER AT THE BODY MOUNTS CHECK CABLES AND GROUND STRAP

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

I have a 2004 Saturn Vue FWD with a 3.5l Honda Pilot engine J35. Where is the crankshaft position sensor located?

Hi,

it could be underneath the car or under the hood. Please acquire a picture of the part and start by checking each place. If not able to locate the image, then please call GM (i believe owner of Saturn) to ask technicians to give specific location and any associated diagrams for finding it.

Thank you.
0helpful
2answers

Location for crankshaft sensor on 2003 Saturn Vue

I looked at info for 4 cylinder engine, 2.2L
You have to remove starter motor to get at it, so says my database.

26373346-yf5ehlbgiggpioegfpvcvx0w-4-0.jpg

26373346-yf5ehlbgiggpioegfpvcvx0w-4-2.jpg
1helpful
1answer
0helpful
2answers

O3 saturn vue v6 all wheel drive. suv will shut off while going down road. put car in nut, shut off key and restart, will not stop again, for a few miles. have put in new fuel pump, new filter, cleaned out...

check for vacuum leaks at upper plenum halves . I just got one in shop with that kinda problem and it has lean codes in memory along with throttle code . it is leaking at spot below throttle body and top left corner . engine has a slight higher idle . codes are PO171,PO174,PO507 AND HAVE NO GASKETS SETS FOR REBUILDING UPPER PLENUM ..
2helpful
1answer

Timing marks on a 2003 saturn vue

My sincere apologies for the severly delayed response.
I am personally going back to answer your unanswered questions.


I do not know if you still need this information, however I am answering it in case you still do.


Click on the following direct Link. It has the Timing Belt Diagrams with Marks for the Camshaft and Crankshaft that you will need.

Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com

http://www.2carpros.com/car_repair_information/year/2003/make/saturn/model/vue/2003_saturn_vue_timing_belt_diagram_marks.htm
0helpful
1answer

Crankshaft position sensor

Usually, the crank sensor sits on the bottom of the engine and usually on the drivers side. Some other places it might be is on the passeger side at the bottom and also on the transmission bellhousing near the bottom on either side. Hope this gives you some direction. Thanks for Using FixYa!

Sincerely,

JC
2helpful
1answer

The electricsal gas pedal

The pedal itself is the sensor. It is all one assembly called the accelerator pedal position sensor. If you are getting a code for this or the throttle position sensor don't assume either are at fault. There are many problems with wiring and the throttle body assembly which contains the throttle position sensor so a thorough diagnosis is needed before any parts should be put on.
0helpful
1answer

2003 Vue won't start after running perfectly

This could be the crankshaft position sensor
0helpful
1answer

Replacing mirrors, etc.

I hope you can find a repair manual by searching the Internet.
Not finding what you are looking for?

112 views

Ask a Question

Usually answered in minutes!

Top Saturn Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Saturn Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...