What is DTC P0335 - 2005 Chevrolet Aveo Sedan

DTC P0054 for HO2S bank 1 sensor 2
DTC P0141 for HO2S bank 1 sensor 2
DTC P0335 Crankshaft Position (CKP) Sensor Circuit

The Crankshaft Position Sensor for the 2.3L 4-Cyl. engine is located behind the crankshaft pulley on the oil pump assembly.



DTC P0335 How To Change Honda Accord Crankshaft Position Sensor

A dtc does not say to relace a part untill diagnostic procedure for said code is preformed . Do you know what a diagnostic trouble chart is ? Factory service repair info. is best .
https://www.obd-codes.com/p0335

Who replaced the sensor ? You or a repair shop ? The DTC P0336 does not say to replace a sensor . You do not have access to the diagnostic trouble code diagnostic's . Your best bet ,take it to a qualified repair shop .
DTC P0336: Crankshaft Position (CKP) Sensor Performance
CKP Sensor Signal Circuit
P0335
P0335
P0335
P0336

P0336
• The ECM detects that the engine is running, but receives less than 51 or more than 65 CKP sensor pulses each engine revolution for 8 of 10 engine revolutions.
• The ECM detects that the engine is running, but more than 19 resyncs occur within 25 seconds.
• The ECM detects that the engine has been running, but the crankshaft does not sync for 0.4 second.

Damaged CKP sensor connector Damaged reluctor ring (missing teeth or not turning due to sheared-off keyway) Sensor output open Sensor output shorted to ground Sensor output shorted to voltage Failed crank sensor Broken timing belt Failed PCM are probable causes

Here is a link to a page simular. DTC P0335 How To Change Honda Accord Crankshaft Position Sensor also you can ask auto parts store, they can help sometimes. Go on ebay an search part, many times the pic where it goes an part shown is there

code po335 refers to crankshaft position sensor(CKP)--circuit malfunction===causes wiring--CKP sensor --ECM
check the air gap and rotor security . Check for dirt in the air gap. Change CKP sensor.
code po113 refers to intake air temperature (IAT) sensor ---circuit malfunction===causes ---wiring open circuit /short circuit to positive ---wiring short to ground---ground wire defective--IAT sensor ---ECM

I need solution for this dtc p0335

Diagnostic Trouble Code (DTC) P0335

Magnetic Crankshaft Position Sensor Electrical Error

In this circuit DTC (data trouble code) sets when

a) The magnetic crankshaft position sensor is > 0.2V.

Or when

b) The minimum value of magnetic crankshaft position sensor is

Or when

c) The maximum value of magnetic crankshaft position sensor is higher than 2.2V.

No.: TSB-07-11-001
DATE: January, 2007
MODEL: 2002-07 Lancer 2.0L
SUBJECT:
HARD TO START ENGINE DTC P0340 (and P0335)

PURPOSE
The engine may be hard or impossible to start and MFI DTC P0335 and possibly P0340 may be stored due to abnormal wear to the camshaft position sensor support. Oil grooves have been added to the camshaft position sensor support to improve lubrication