Hi I am trying to remove the valve cover off me jeep grand Cherokee 2.5 td 1998 there is not enough clearance to get it off the top of the engine .any Ideas please.
SOURCE: 2000 jeep grand cherokee 4.0 liter engine timing belt replacement
If you have the same pulley arrangement that most 4.0 engines have that pulley is an idler not a tensioner. Your power steering pump has a pivot bolt, and a slide under the pump. You adjust belt tension using the pump.
SOURCE: HOW TO REMOVE HEADLIGHT ASSEMBLY 2006 JEEP GRAND CHEROKEE
remove the 7mm bolt in the centre top of lamp unit then with a big screwdriver just behind headlamp prise outwards quite firmly
SOURCE: where to replace coolant temp sensor for 1998 grand jeep cherokee
Check this image...
...in the Section ZJ-Secc-8D-Ignition-Systems (page 5, fig. 10 and 11).
Good luck.
SOURCE: 1998 Jeep Grand Cherokee Laredo 4.oL I got a code po113
Trouble Code: P0113 (4.0L L6 VIN S Auto)
IAT Sensor Circuit High Input
Print this code data
Number of Trips to Set Code: 1
OBD II Monitor Type: CCM Details
Indicators: MIL Details
Trouble Code Conditions:
Check with ignition on or engine running; battery voltage more than 10v; The PCM detected the IAT Sensor input was over 4.90v (exc. Dakota, Durango, Ram) or 4.98v (Dakota, Durango, Ram) for 3 seconds.
Possible Causes:
SOURCE: change a headlight assembly Jeep Grand Cherokee
Just need take off the screws; for details check the graphics and ilustrations in the Jeep ZJ Grand Cherokee Service Manual
Hope helps (remember rated this) Good luck..
142 views
Usually answered in minutes!
×