- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Check fuses, front and back wiper motors run on different fuses. Test for power and ground at front wiper motor wires. If you have power and ground there your wiper motor may be toast. Good luck
NOTE
A new wiper motor assembly comes with the linkage arm installed.
Before servicing the vehicle, refer to the Precautions Section.
Remove the windshield wiper mounting arm and pivot shaft
WARNING
Do not remove the wiper motor linkage arm from the wiper motor
assembly. If the arm is removed, the wiper arms may not park in the
correct location.
NOTE
Use a suitable tool to separate the wiper linkage arm from the wiper mounting arm and pivot shaft assembly.
Remove the 3 bolts and the wiper motor.
Fig. Wiper motor and linkage
To install:
Install wiper motor and bolts.
Tighten wiper motor bolts to 10 ft. lbs. (13 Nm).
Install windshield wiper mounting arm and pivot shaft.
Check wiper operation.
Rear Wiper Motor - Removal & Installation
Remove the rear pivot arm.
Remove the rear wiper motor shaft nut cover
Remove the rear wiper motor shaft nut.
Open the lift gate window.
Remove the rear wiper motor cover trim panel.
Disconnect the electrical connector.
Remove the 2 rear window wiper motor nuts
Remove the rear window wiper motor.
Fig. Rear wiper motor view-2008 model shown, other years similar
To install:
Install rear wiper motor and tighten mounting nuts to 62 inch lbs. (7 Nm).
Reconnect the electrical connector.
Install wiper motor cover trim panel.
Install rear wiper pivot arm tighten nut to 53 inch lbs. (6 Nm).
No solution sorry - mine have done exactly the same - will wipe front screen if you mess with the stalk - rear wiper works when you push the stalk forwards or backwards but no washer to either - have you found a solution? Kind regards - Andy
check for power at the wiper motor. If power at the wiper motor but no wiper action then replace the motor. if no power at the motor then use a jumper wire and put power to the motor. Does motor run? if so check for open circuit in the wire someplace.
×