Replace the rear freeze plug of a 1995 Ford Mustang 3.8L, V-6 engine.
SOURCE: freeze plugs ford econoline 150
The freeze plugs can be fixed with the engine in the veicle. There are some rubber plugs available that have a bolt thru the middle. Pry out failed plug, push in rubber replacement, tighten bolt to expand rubber. Fixed.
SOURCE: 2006 Ford mustang check engine light come on
You need to have it scanned to see what code turned on the light. Check your gas cap, make sure it is tight.
SOURCE: rear wheel bearing
SECTION 205-02B: Rear Drive Axle/Differential — Ford 8.8-Inch Ring Gear
2003 Mustang Workshop Manual
IN-VEHICLE REPAIR
Axle Shaft
Removal
Remove the U-washer (4N237).
Carefully remove the rear brake anti-lock sensor. For additional information, refer to Section 206-09A .
--------------------------------------------------------------------------------------
Remove the axle shaft.
Rear Wheel Bearing and Axle Shaft Oil Seal
Removal
Installation
Using the special tools, remove the rear wheel bearing and wheel bearing oil seal.
-------------------------------------------------------------------
Installation
Install the two axle shafts.
Install the U-washer.
Install the differential pinion shaft.
SOURCE: rear main seal is leaking on a Ford Mustang 2003 V-6
In order to replace the rear main seal u have to pull the transmission out to access it, u will need a special seal installer tool to install the new rear main "full circle seal", it u don't use the special ford tool the seal will leak again, also if there is a groove worn ion the crankshaft the crank must be repaired or replaced or the or the seal will leak again, so this is avery diff job, a 9 on the scale of 1-10 with 10 being the mos difficult.
SOURCE: 98 ford mustang
If your having problems with the rear piston going in it because you need a special tool that allows you to turn while pushing.
836 views
Usually answered in minutes!
×